Nios编程：No CFI table found问题的解决

写入flash程序的时候，系统提示：

[SOPC Builder]$ nios2-flash-programmer --device=1 --instance=0 --base=0x0000000
0 cfi_flash_Share.flash
Using cable "ByteBlasterII [LPT1]", device 1, instance 0x00
Resetting and pausing target processor: OK
No CFI table found at address 0x00000000
Leaving target processor paused 

鼓捣了半天都没有成功，没办法只得查看《Nios II Flash Programmer User Guide》--altera，后面附录一节很详细。

When you run the flash programmer to program CFI flash memory, you
get the error: "No CFI table found at address <base address>"
Probable Cause
The flash programmer can connect with a Nios II JTAG debug module in
the FPGA, but it can not successfully execute a query to a flash memory
at the base address specified.
Suggested Actions
■ If you are using nios2-flash-programmer in command-line mode,
make sure you specified the correct base address for the CFI device.