思科动态路由协议RIP

思科动态路由协议

1. 规划网段（路由是隔离网段的）
   

1. 配置每个节点IP地址。
   

R0
Router(config)#interface f0/0
Router(config-if)#no shutdown
Router(config-if)#ip address 192.168.10.1 255.255.255.0
Router(config-if)#exit
Router(config)#interface f0/1
Router(config-if)#ip address 192.168.20.1 255.255.255.0
Router(config-if)#no shutdown
R1
Router(config)#interface f0/0
Router(config-if)#no shutdown
Router(config-if)#ip address 192.168.20.2 255.255.255.0
Router(config-if)#exit
Router(config)#interface f0/1
Router(config-if)#no shutdown
Router(config-if)#ip address 192.168.30.1 255.255.255.0
Router(config-if)#exit
R2
Router(config)#interface f0/0
Router(config-if)#no shut
Router(config-if)#ip address 192.168.30.2 255.255.255.0
Router(config-if)#exit
Router(config)#interface f0/1
Router(config-if)#no shutdown
Router(config-if)#ip address 192.168.40.1 255.255.255.0

动态路由协议（RIP)：
配置起来相当简单。
查看自已的路由表，然后把自已带C的网段添加rip就可以了。
R0
Router#show ip route
C 192.168.10.0/24 is directly connected, FastEthernet0/0
C 192.168.20.0/24 is directly connected, FastEthernet0/1
Router#conf t
Router(config)#
Router(config)#router rip
Router(config-router)#network 192.168.10.0
Router(config-router)#network 192.168.20.0
R1
Router#show ip route
C 192.168.20.0/24 is directly connected, FastEthernet0/0
C 192.168.30.0/24 is directly connected, FastEthernet0/1
Router#conf t
Router(config)#router rip
Router(config-router)#network 192.168.20.0
Router(config-router)#network 192.168.30.0
R2
Router#show ip route
C 192.168.30.0/24 is directly connected, FastEthernet0/0
C 192.168.40.0/24 is directly connected, FastEthernet0/1
Router#conf t
Router(config)#router rip
Router(config-router)#network 192.168.30.0
Router(config-router)#network 192.168.40.0
不管是静路由协议还是动态路由协议最终的目的都是为了让每台三层设备都有所有的网段。