串口接收中断进不去，如何解决

串口配置代码

void  USART_Configuration(void)
{
  GPIO_InitTypeDef GPIO_InitStructure;
  USART_InitTypeDef USART_InitStructure;
  RCC_APB2PeriphClockCmd(RCC_APB2Periph_USART1 | RCC_APB2Periph_GPIOA |RCC_APB2Periph_AFIO, ENABLE); 


  GPIO_InitStructure.GPIO_Pin = GPIO_Pin_9;         
  GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP;   
  GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
  GPIO_Init(GPIOA, &GPIO_InitStructure);   


  GPIO_InitStructure.GPIO_Pin = GPIO_Pin_10;          
  GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN_FLOATING;  
  GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
  GPIO_Init(GPIOA, &GPIO_InitStructure);          

  USART_InitStructure.USART_BaudRate = 9600;
  USART_InitStructure.USART_WordLength = USART_WordLength_8b;
  USART_InitStructure.USART_StopBits = USART_StopBits_1;
  USART_InitStructure.USART_Parity = USART_Parity_No;
  USART_InitStructure.USART_Mode =  USART_Mode_Rx ;
  USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;


  /* Configure USART1 */
  USART_Init(USART1, &USART_InitStructure);
  USART_ITConfig(USART1, USART_IT_RXNE, ENABLE);  
  USART_Cmd(USART1, ENABLE);

以上是出现问题的配置代码，这里面注意两个地方

1：  USART_ITConfig(USART1, USART_IT_RXNE, ENABLE); 

一定要将接收中断使能

2：  USART_InitStructure.USART_Mode =  USART_Mode_Rx ;

这个比较重要，之前一直忽视了模式配置，后来改成全双工后，就串口接收中断就可以正常使用了