手把手教你使用 Raspberry - Wireless-Access-Point

RPI Wireless-Access-Point

将Raspberry Pi3 作为无线路由接入点

• Install the necessary software.

  $ sudo apt-get install hostapd udhcpd

• Configure DHCP /etc/udhcpd.conf

  $ sudo nano /etc/udhcpd.conf
  
  // 将文件修为为如下内容：
  
  start 192.168.42.2 # This is the range of IPs that the hostspot will give to  client devices.
  end 192.168.42.20
  interface wlan0 # The device uDHCP listens on.
  remaining yes
  opt dns 8.8.8.8 4.2.2.2 # The DNS servers client devices will use.
  opt subnet 255.255.255.0
  opt router 192.168.42.1 # The Pi's IP address on wlan0 which we will set up shortly.
  opt lease 864000 # 10 day DHCP lease time in seconds

• Edit the file /etc/default/udhcpd and change the line:

  DHCPD_ENABLED="no"

  to

  
  #DHCPD_ENABLED="no"
  

• Configure Network

  allow-hotplug wlan