config
CE1 、CE2
>system-view immediately ## 输入命令立即设生效,避免输入commit 麻烦
## CE1
配置底层underlay网络
interface GE1/0/0
undo portswitch
undo shutdown
ip add 12.0.0.1 24
int lo0
ip add 1.1.1.1 24
ospf 1
are 0
int G1/0/0
ospf enable are 0
int lo0
ospf enable are 0
##CE2
CE2
interface GE1/0/0
undo portswitch
undo shutdown
ip address 12.0.0.2 255.255.255.0
ospf enable 1 area 0.0.0.0
interface LoopBack0
ip address 2.2.2.2 255.255.255.0
ospf enable 1 area 0.0.0.0
ospf 1
area 0.0.0.0
SW1、SW2
##SW1
vlan batch 10
interface GigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 2 to 4094
interface GigabitEthernet0/0/2
port link-type access
port default vlan 10
##SW2
vlan batch 20
interface GigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 2 to 4094
interface GigabitEthernet0/0/2
port link-type access
port default vlan 20
配置vxlan
##CE1
bridge-domain 10
vxlan vni 10
interface GE1/0/1.1 mode l2
encapsulation dot1q vid 10 ## vlan id为10 的数据包允许进入隧道
bridge-domain 10
interface Nve1
source 1.1.1.1
vni 10 head-end peer-list 2.2.2.2
##CE2
bridge-domain 10
vxlan vni 10
interface GE1/0/1.1 mode l2
encapsulation dot1q vid 20 ## vlan id为20 的数据包允许进入隧道
bridge-domain 10
interface Nve1
source 2.2.2.2
vni 10 head-end peer-list 1.1.1.1
测试: