centos7安装redis6.0时make报错问题

因工作需要，在一台云服务器上安装redis
服务器系统为centos7，直接在redis官网查找地址，wget、tar后，执行马克命令时发现报错

             serverLog(LL_NOTICE,"The server is now ready to accept connections at %s", server.unixsocket);
                                                                                              ^
server.c:5103:19: error: ‘struct redisServer’ has no member named ‘supervised_mode’
         if (server.supervised_mode == SUPERVISED_SYSTEMD) {
                   ^
server.c:5104:24: error: ‘struct redisServer’ has no member named ‘masterhost’
             if (!server.masterhost) {
                        ^
server.c:5117:15: error: ‘struct redisServer’ has no member named ‘maxmemory’
     if (server.maxmemory > 0 && server.maxmemory < 1024*1024) {
               ^
server.c:5117:39: error: ‘struct redisServer’ has no member named ‘maxmemory’
     if (server.maxmemory > 0 && server.maxmemory < 1024*1024) {
                                       ^
server.c:5118:176: error: ‘struct redisServer’ has no member named ‘maxmemory’
         serverLog(LL_WARNING,"WARNING: You specified a maxmemory value that is less than 1MB (current value is %llu bytes). Are you sure this is what you really want?", server.maxmemory);
                                                                                                                                                                                ^
server.c: In function ‘hasActiveChildProcess’:
server.c:1476:1: warning: control reaches end of non-void function [-Wreturn-type]
 }
 ^
server.c: In function ‘allPersistenceDisabled’:
server.c:1482:1: warning: control reaches end of non-void function [-Wreturn-type]
 }
 ^
server.c: In function ‘writeCommandsDeniedByDiskError’:
server.c:3747:1: warning: control reaches end of non-void function [-Wreturn-type]
 }
 ^
server.c: In function ‘iAmMaster’:
server.c:4914:1: warning: control reaches end of non-void function [-Wreturn-type]
 }
 ^
make[1]: *** [server.o] Error 1
make[1]: Leaving directory `/usr/src/redis-6.0.1/src'
make: *** [install] Error 2

gcc等环境都已经安装，清除编译信息后重新编译、删除解压后的文件重新解压编译的方式都试过了没有改善，后来查到与gcc的版本有关

//查看gcc版本
gcc -v

centos7默认版本为4.8.5

而redis6.0+需要的gcc版本为5.3及以上，所以升级gcc即可

//升级gcc到9以上
yum -y install centos-release-scl
yum -y install devtoolset-9-gcc devtoolset-9-gcc-c++ devtoolset-9-binutils

还需要执行命令

//临时将此时的gcc版本改为9
scl enable devtoolset-9 bash
//或永久改变
echo "source /opt/rh/devtoolset-9/enable" >>/etc/profile

查看gcc此时版本

再执行编译命令即可完成编译