SNS光纤交换机怎样禁用 Virtual Fabric模式

解决方案
1、fosconfig --show查看VF模式是否启用
DCXa:FID128:admin> fosconfig --show

FC Routing service: enabled

iSCSI service: Service not supported on this Platform

iSNS client service: Service not supported on this Platform

Virtual Fabric: enabled

Ethernet Switch Service: disabled

DCXa:FID128:admin>

 

2、将所有端口移动到默认的logic switch，默认logic switchFID为128

DCXa:FID128:admin> lscfg --config 128 -slot 1-4 -port 0-31 //将slot1-4，每个slot上0-31端口移到FID为128的logic switch
This operation requires that the affected ports be disabled.

Would you like to continue [y/n]?: y

lscfg: A port or ports is already in the current switch.

 

3、删除非默认logic switch，删除前需要通过命令lscfg --show 可以查看FID

4、使用命令lscfg --delete FID删除logic switch（注意：默认logic switch无法删除）

DCXa:FID128:admin> lscfg --delete 128（此处128替换为lscfg）

Unable to delete the default switch.

5、使用命令fosconfig --disable vf禁用Virtual Fabric

DCXa:FID128:admin> fosconfig --disable vf

WARNING: This is a disruptive operation that requires a reboot to take effect.

Would you like to continue [Y/N]: y

Please delete all but the default switch before disabling Virtual Fabric.

6、再次查看Virtual Fabric

DCXa:FID128:admin>

DCXa:FID128:admin> fosconfig --show

FC Routing service: enabled

iSCSI service: Service not supported on this Platform

iSNS client service: Service not supported on this Platform

Virtual Fabric: disabled

Ethernet Switch Servic

 

转载：https://support.huawei.com/enterprise/zh/knowledge/EKB1000765145?idAbsPath=7919749|7941815|250389224|21462744|21126716|