H3C--VRRP负载均衡--冗余设备(带源码)

拓扑图

1. 第一步 配置PC
   vlan10
   IP10.1.1.5
   GW 10.1.1.111
   
   第二台 PC

vlan20
IP20.1.1.5
GW 20.1.1.111

2. 在交换机上放通VLAN,并给连接终端(PC)的接口打上access口

连接终端交换机 SW3
interface GigabitEthernet1/0/1
 port link-type trunk
 port trunk permit vlan all
#
interface GigabitEthernet1/0/2
 port link-type trunk
 port trunk permit vlan all
#
interface GigabitEthernet1/0/3
 port access vlan 10
 stp edged-port

连接终端交换机 SW4
interface GigabitEthernet1/0/1
 port link-type trunk
 port trunk permit vlan all
#
interface GigabitEthernet1/0/2
 port link-type trunk
 port trunk permit vlan all
#
interface GigabitEthernet1/0/3
 port access vlan 20
 stp edged-port

网关交换机 SW1
interface GigabitEthernet1/0/1
 port link-type trunk
 port trunk permit vlan all
#
interface GigabitEthernet1/0/2
 port link-type trunk
 port trunk permit vlan all
#
interface GigabitEthernet1/0/3
  port link-type trunk
 port trunk permit vlan all


网关交换机 SW2
interface GigabitEthernet1/0/1
 port link-type trunk
 port trunk permit vlan all
#
interface GigabitEthernet1/0/2
 port link-type trunk
 port trunk permit vlan all
#
interface GigabitEthernet1/0/3
  port link-type trunk
 port trunk permit vlan all

3. 配置VRRP 并配置优先级120 成为master

SW1
VLAN10为 主
interface Vlan-interface10
 ip address 10.1.1.1 255.255.255.0
 vrrp vrid 1 virtual-ip 10.1.1.111
 vrrp vrid 1 priority 120
 vrrp vrid 1 preempt-mode delay 1000

VLAN 20 为备
interface Vlan-interface20
 ip address 20.1.1.1 255.255.255.0
 vrrp vrid 2 virtual-ip 20.1.1.111

SW2
interface Vlan-interface10
 ip address 10.1.1.2 255.255.255.0
 vrrp vrid 1 virtual-ip 10.1.1.111

interface Vlan-interface20
 ip address 20.1.1.2 255.255.255.0
 vrrp vrid 2 virtual-ip 20.1.1.111
 vrrp vrid 2 priority 120
 vrrp vrid 2 preempt-mode delay 1000

4. 验证配置与是否可以切换链路

SW1

我们shutdown SW1 的 1/0/2 接口 测试是否切换
此时 vlan10 SW1 是master