Question Analysis of the Crusher Workflow

It is understood that the problems of the crusher at work occurred,  we  should pay attention to the following points:
      A. When the Crusher is working, we should pay attention whether the nesting is smooth, which is an important part of the machines work properly. At the design time, although we made some efforts,  the two palatal plate the maximum angle less than 12 degrees, but the question still exist in the use of nesting poor. Later on, we changed the shape of the palate, plus an adjustment of two palatal pull angle adjustment skids, solve this problem better.               

      2. In order to facilitate the exclusive regulation of the discharge port size,we adopt the pad adjustment. Turn the adjusting bolt top overruns board, and then add or win adjust Horn, to achieve the required angle between the moving palate plate and palate. Cycle and then adjust the bolt, so that the adjusting screw from the force in the course of their work, breaking force the body to pass through the horns.

 
      3. Due to the poor working conditions of the crusher, the dust is serious, the bearing is particularly easy to wear, so we should properly deal with the problem of bearing seal.we adopt the multi-layer sealing method, and often pay attention to the lubrication work, in order to maintain its good working condition.
  

      4. According to the requirements, the crusher is equipped with separation sieve to separate the material after crushing block and powder, without prior screening. Material block can be used directly.
   
Mining crusher is the crushing machinery whose  content is more than 50%  of the total,the row compound particles is larger than three millimeters. Which is invented by British Heng.  according to the size of feeding and nesting granularity,The crushing operations is often divided  into the rough crushing,middle crushing and fine crushing. The crusher is widely used in many sectors of mining, smelting, building material, highway, railway, water conservancy and chemical industry.The general used equipments are jaw crusher, impact crusher, impact crusher, compound crusher, single-stage hammer crusher, vertical crusher, gyratory crusher, cone crusher, roll crusher machine, double roll crusher, two-in-one crusher and so on.
After a year of the crusher use, the machine efficiency is high, the labor intensity is low. The Inadequacies are: the noisy is big when the machine is working, the dust higher. mineral processing equipment is essential, so the careful operation is needed. 
  

转载于:https://www.cnblogs.com/dvbcxb/archive/2012/08/13/2636648.html