通用电气DS200QTBDG1AAA处理器模块

产品标题: 通用电气DS200QTBDG1AAA处理器模块

型号：DS200QTBDG1AAA

品牌：GE

 

                                                         产品详情资料：

电流或电压输出每个通道的范围及其在电流或电压模式下的操作通过模块端子上的跳线设置。对于电压操作，可以使用250欧姆电阻器代替电压跳线来增加电压范围。下表列出了可以为每个输出设置的输出范围，以及每个范围的跳线或电阻器设置。输出默认值如果CPU进入停止模式或重置，则两个模块输出都可以设置为默认值0或4 mA或保持***状态。GE Multilin UR8HH使用接线板上的另一跳线设置模块的输出默认操作。如果输出默认（DEF0/4）跳线安装在模块端子11和13上，则两个输出默认为其范围的低端。如果未安装输出默认跳线，则两个输出保持从PLC CPU接收的***一个有效输出值。此选项需要一个外部+24 VDC电源，以在系统电源下降时保持输出功率。8通道模拟电流/电压输出模块；IC694ALG392提供多达八个单端输出通道，具有电流回路输出和/或电压输出。可以使用配置软件为以下任何范围设置每个输出通道：? 0至+10伏（单极）? 10至+10伏（双极）? 0至20毫安? 4至20毫安

                                                          产品英文详情料:

Current or Voltage Outputs Each channel’s range and its operation in current or voltage mode are set with jumpers on the module terminals. For voltage operation, a 250 Ohm resistor can be used instead of a voltage jumper to increase the voltage range. The table below lists the output ranges that can be set up for each output, and the jumper or resistor settings for each range.Output Defaults Both module outputs can be set to either Default to 0 or 4 mA or Hold Last State if the CPU goes to Stop mode or is Reset. The module’s Output Default operation is set using another jumper on the terminal block. If the Output Default (DEF0/4) jumper is installed on module terminals 11 and 13, both outputs default to the low end of their ranges. If the Output Default jumper is not installed, both outputs hold the last valid output value received from the PLC CPU. This option requires an external +24 VDC power supply to maintain output power when the system power goes down.The 8–Channel Analog Current/Voltage Output module; IC694ALG392, provides up to eight single-ended output channels with current loop outputs and/or voltage outputs. Each output channel can be set up using the configuration software for any of these ranges: ? 0 to +10 volts (unipolar) ? 10 to +10 volts (bipolar) ? 0 to 20 milliamps ? 4 to 20 milliamps