Verilog HDL串口发送程序

module myuart_trans(
    input clk,   
    input rst,
    input TransEn,           //transmit able
    input[7:0] DataToTrans,  //Data prepared for transmitting
    output reg BufFull,      //Data buffer is full
    output reg tx,           //serial data out
    output reg gnd=1'b0
);

//对50MHz晶振进行分频，3.125MHz
reg[7:0] count;
reg clk16x;
always@(posedge clk or posedge rst)
    if(rst) 
        begin
            count<=8'd0;
            clk16x=1'b0;
        end
    else if(count>=8'd125)
        begin
            count<=1'b0;
            clk16x=~clk16x; 
        end
    else count<=count+1'b1;
    
//capture the falling edge of TransEn
reg TransEn_r;
wire pos_tri;
always@(posedge clk16x or posedge rst)
    if(rst) TransEn_r <= 1'b0;
    else TransEn_r <= TransEn;
assign pos_tri = TransEn_r & ~TransEn;

// when the falling edge of TransEn,load the Data to buffer
reg[7:0] ShiftReg;
always@(negedge pos_tri or posedge rst)
    if(rst) ShiftReg <= 8'b0;
    else ShiftReg <= DataToTrans;
    
//counter control
reg cnt_en;
always@(posedge clk16x or posedge rst)
    if(rst)
        begin
            cnt_en <= 1'b0;
            BufFull <= 1'b0;
        end
    else if(pos_tri==1'b1)
        begin
            cnt_en <= 1'b1;
            BufFull <= 1'b1;
        end
    else if(cnt==168)
        begin
            cnt_en <= 1'b0;
            BufFull <= 1'b0;
        end
        
//counter module
reg[7:0] cnt;
always@(posedge clk16x or posedge rst)
    if(rst) cnt <= 8'd0;
    else if(cnt_en) cnt <= cnt+1'b1;
    else cnt <= 8'd0;
    
//transmit module
always@(posedge clk16x or posedge rst)
    if(rst) tx <= 1'b1;
    else if(cnt_en)
        case(cnt)
            8'd8: tx <= 1'b0;
            8'd24: tx <= ShiftReg[0];
            8'd40: tx <= ShiftReg[1];
            8'd56: tx <= ShiftReg[2];
            8'd72: tx <= ShiftReg[3];
            8'd88: tx <= ShiftReg[4];
            8'd104: tx <= ShiftReg[5];
            8'd120: tx <= ShiftReg[6];
            8'd136: tx <= ShiftReg[7];
            8'd152: tx <= 1'b1;
        endcase
    else tx <= 1'b1;
    
endmodule

 

转载于:https://www.cnblogs.com/Mungbohne/p/4376427.html