STM32学习知识总结（二）

stm32f407外部中断配置

void My_EXTI_Init()
{
   EXTI_InitTypeDef EXTI_InitStructure;  
   NVIC_InitTypeDef NVIC_InitStructure;
   
   RCC_APB2PeriphClockCmd(RCC_APB2Periph_SYSCFG, ENABLE);                //配置GPIO与中断线的映射关系，那么我们首先需要打开SYSCFG时钟
   SYSCFG_EXTILineConfig(EXTI_PortSourceGPIOE,EXTI_PinSource3);          //将GPIO端口与中断线映射起来
   RCC_AHB1PeriphClockCmd(RCC_AHB1Periph_GPIOE,ENABLE);					 //使能端口时钟
   
   //GPIO配置
   GPIO_InitTypeDef GPIO_InitStructure;
   GPIO_InitStructure.GPIO_Pin = GPIO_Pin_3;            //声明管脚为PE3
   GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN;         //输入模式
   GPIO_InitStructure.GPIO_PuPd = GPIO_PuPd_UP;         //由于该端口低电平视为有效，所以默认为高电平
   GPIO_Init(GPIOE, &GPIO_InitStructure); 
   
   //优先级配置
   NVIC_InitStructure.NVIC_IRQChannel = EXTI3_IRQn;//EXTI3中断通道
   NVIC_InitStructure.NVIC_IRQChannelPreemptionPriority=2;//抢占优先级
   NVIC_InitStructure.NVIC_IRQChannelSubPriority =1;		//子优先级
   NVIC_InitStructure.NVIC_IRQChannelCmd = ENABLE;			//IRQ通道使能
   NVIC_Init(&NVIC_InitStructure);	//根据指定的参数初始化VIC寄存器
  
   //中断配置
   EXTI_InitStructure.EXTI_Line=EXTI_Line3; 
   EXTI_InitStructure.EXTI_Mode=EXTI_Mode_Interrupt;
   EXTI_InitStructure.EXTI_Trigger=EXTI_Trigger_Rising;   //上升沿触发
   EXTI_InitStructure.EXTI_LineCmd=ENABLE;
   EXTI_Init(&EXTI_InitStructure);
}
unsigned long long t=0;
void EXTI3_IRQHandler(void)
{
	if(EXTI_GetITStatus(EXTI_Line3)==1)
	{
   		 t++;
	}
	EXTI_ClearITPendingBit(EXTI_Line3);
}

	亲测可以正常使用。