H3C华三链路聚合配置

题目要求：在 S2、S3 上创建链路聚合组 1，S2 和 S3 之间通过链路聚合增加链路可靠性，模式采用静态聚合。

S2配置

[S2]interface Bridge-Aggregation 1                   #创建静态链路聚合组1

[S2-Bridge-Aggregation1]port link-type trunk        #将链路聚合组接口类型设置为trunk

[S2-Bridge-Aggregation1]port trunk permit vlan all   #设置链路聚合组接口允许通过的vlan

[S2-Bridge-Aggregation1]quit                          #退出链路聚合组视图

[S2]interface range Gigabitethernet 1/0/1 to Gigabitethernet 1/0/2 #进入g1/0/1到g1/0/2的接口视图

[S2-if-range]port link-type trunk                #将接口类型设置为trunk

[S2-if-range]port trunk permit vlan all             #设置允许通过的vlan

[S2-if-range]port link-aggregation group 1      #将接口加入到聚合组

[S2-if-range]quit                             #退出接口视图   

S3配置

[S3]interface Bridge-Aggregation 1                    #创建静态链路聚合组1

[S3-Bridge-Aggregation1]port link-type trunk       #将链路聚合组接口类型设置为trunk

[S3-Bridge-Aggregation1]port trunk permit vlan all   #设置链路聚合组接口允许通过的vlan

[S3-Bridge-Aggregation1]quit                          #退出链路聚合组视图

[S3]interface range Gigabitethernet 1/0/1 to Gigabitethernet 1/0/2 #进入g1/0/1到g1/0/2的接口视图

[S3-if-range]port link-type trunk                #将接口类型设置为trunk

[S3-if-range]port trunk permit vlan all             #设置允许通过的vlan

[S3-if-range]port link-aggregation group 1      #将接口加入到聚合组

[S3-if-range]quit                             #退出接口视图  

验证一下配置的结果，用display current-configuration查看配置

可以看到我们配置成功了