高通切换到Emergency Download：adb reboot edl

小黄人软件

于 2023-12-20 13:28:32 发布

阅读量1.6k

点赞数 18

分类专栏：日志文章标签： adb

本文链接：https://blog.csdn.net/chenhao0568/article/details/135105773

版权

日志专栏收录该内容

433 篇文章 5 订阅

订阅专栏

本文详细介绍了如何使用ADB命令adbrebootedl将Android设备置于EDL模式，适用于进行底层固件更新或修复无法正常启动的设备。但需谨慎，仅适用于熟悉固件修改的高级用户或开发者。

摘要由CSDN通过智能技术生成

刷机开机下adb reboot edl 切到QDloader 9008 点下载。

在这里插入图片描述

The command “adb reboot edl” is used to reboot an Android device into EDL (Emergency Download) mode using the Android Debug Bridge (ADB) tool. EDL mode is primarily used for low-level firmware flashing or unbricking devices that cannot be booted into the standard operating system.

To use this command, you must have ADB installed on your computer and your Android device connected via USB with USB debugging enabled. Here’s a general guide on how to use the command:

Install ADB: If you haven’t already installed ADB on your computer, you can download it from the official Android developer website.
Enable USB Debugging: On your Android device, go to “Settings” > “About phone” and tap “Build number” seven times to enable developer options. Then, go to “Settings” > “Developer options” and enable “USB debugging”.
Connect Your Device: Connect your Android device to your computer using a USB cable.
Open Command Prompt or Terminal: On your computer, open a command prompt (Windows) or terminal (Linux or macOS).
Check Device Connection: Type adb devices to check if your device is properly connected. If connected, you’ll see your device’s serial number listed.
Enter the Command: Type adb reboot edl and press Enter. Your device should reboot into EDL mode.

It’s important to note that not all devices support EDL mode, and using EDL mode can be risky if you’re not familiar with firmware flashing. It’s primarily used by advanced users or developers for deep-level modifications or repairs. If you’re unsure about using EDL mode, it’s advisable to seek assistance from someone experienced with Android firmware.