Bring Their Role to Full Play

There are many grinding machines,such as ball mill, raymond mill, MTM Trapezium grinding mill,high pressure suspension grinding machine,etc.

As you can see, there is a growing rapid of mining machine developping. However you will save a lot of cost if you know how to maintain ball mill in a

good state or to make impact crusher work for longer life time. Carefully read the article below and you will can learn much about these.

The performance of ordinary hydraulic pressure cone crusher can acts as the reference for the performance of HP series cone crusher. As a composing unit

of the production line, its performance can be influenced by other units like feeder, belt conveyor, vibrating screen, motor, transmission part and hopper,

etc.

The following character can decrease the capacity of Hydraulic Pressure:

1. the fine particle with size less than that of feeding hole surpass the max. capacity of the crusher by the extent of 10%;

2. Sticky materials mixed in the feeding;

3. No feeding control;

4. Materials allocated improperly around the crushing cavity;

5. The recommended power not used;

6. Screening capacity not enough;

7. Discharge opening now works normally;

8. Materials too hard or too elastic.

After mining ore has been sufficiently crushed by use of a jaw crusher, gyratory crusher or impact crusher, the next step is to grind that material down to

even finer powders and particles for processing. There are several types of used grinding equipment that can be utilized to perform. this task including ball

mills, rod mills, sag mills and hammer mills. Each type of grinding press has its advantages depending on the mining ore being used.

Rod mills are quite similar to ball mills but use long steel rods instead of small balls for the grinding media. Steel rods grind the ore by tumbling within the

mill and the rods tumble and spin in roughly parallel alignments simulating a series of roll crushers. Since a rod mill doesn't cascade it can be operated at a

lower peripheral speed than a ball mill and since there is less void space in a rod mill than a ball mill there is usually more grinding contact between metal and

ore.

Ball mills are cylindrical devices that rotate around a horizontal axis and are partially filled with the material too be ground and the grinding medium. Often

ball grinding medium consist of ceramic balls, flint pebbles and stainless steel balls. Ball mills operate via an internal cascading motion where the grinding

balls and the ore grind together to reduce the material to a fine powder. Industrial ball mills can operate continuously, being fed at one end with the ore and

discharging the fine powder at the other end.

Hammer mills, unlike ball and rod mills, act to shred mining ore rather than grind it. A hammer mill consists of a steel drum with a vertical or horizontal

rotating shaft on which hammers are mounted. The hammers will swing freely from a fixed point on the central rotor and when material is fed into the mill

the rotor is spun at a high speed so the hammers can shred the ore material that is then expelled through screens in the drum.

来自 “ ITPUB博客 ” ，链接：http://blog.itpub.net/26787532/viewspace-720388/，如需转载，请注明出处，否则将追究法律责任。

转载于:http://blog.itpub.net/26787532/viewspace-720388/