Gentoo下安装ZTE 2736上网卡安装设置备忘

 

得一块ZTE 2736的中国电信3G上网卡，通过一个小时google加研究，终于安装成功，以下是备忘。

 

 

1、编译内核 （补充见注解）
     Device Drivers  --->    
        [*] USB support  ---> 
             <M>   USB Serial Converter support  --->
                 --- USB Serial Converter support                                          │ │ 
                  │ │    [ ]   Functions for loading firmware on EZUSB chips                       │ │ 
                  │ │    [*]   USB Generic Serial Driver                              

 

2、安装usb_modeswitch

emerge -av usb_modeswitch

 

3、编辑usb_modeswitch.conf

vim /etc/usb_modeswitch.conf

添加或修改为以下内容

DefaultVendor=  0x19d2
DefaultProduct= 0xfff5
TargetVendor=   0x19d2
TargetProduct=  0xfffe
MessageContent="5553424312345678c00000008000069f030000000000000000000000000

4、插上USB上网卡

# lsusb

输出结果为

# lsusb | grep -i ONDA
Bus 006 Device 005: ID 19d2:fffe ONDA Communication S.p.A.

 

执行usb_modeswitch

# usb_modeswitch && lsusb

输出结果为

Bus 006 Device 005: ID 19d2:fff1 ONDA Communication S.p.A.

其中fff1表示已将设备从usb storage切换到3G设备模式。

 

5、安装配置wvdial

# emerge -av wvdial

 

配置/etc/wvdial.conf

# vim /etc/wvdial.conf

新建或修改为以下内容

 

[Modem0]
Modem=/dev/ttyUSB0
Baud=921600
SetVolume=0
Dial Command=ATDT
Init1=ATZ
FlowControl=Hardware(CRTS CTS)
[Dialer 3g]
Username=ctnet@mycdma.cn
Password=vnet.mobi
Phone=#777
Stupid Mode=1
Inherits=Modem0

 

6、拔号

# wvdial 3g

 

7、拔号成功

拔号成功后输出以下内容，尝试一下是否可以上网.

 

# wvdial 3g
--> WvDial: Internet dialer version 1.60
--> Initializing modem.
--> Sending: ATZ
ATZ
OK
--> Modem initialized.
--> Sending: ATDT#777
--> Waiting for carrier.
ATDT#777
CONNECT
--> Carrier detected.  Starting PPP immediately.
--> Starting pppd at Thu Feb 11 17:37:25 2010
--> Pid of pppd: 7851
--> Using interface ppp0
--> local  IP address 114.81.151.243
--> remote IP address 115.168.41.16
--> primary   DNS address 124.74.213.68
--> secondary DNS address 202.109.14.5