how should do quarry Crusher equipment rusting

The metal of a class of things, especially the metal iron is apt to rust, and we used everyday crusher equipment such as cone crusher, quarry crusher, sand making machine or milling machine and almost every part of the parts or accessories are metal iron forged, if in the process of use or use in the maintenance or protection on it, then this type of crusher is easy to rust and reduces the production efficiency and even lead to products that do not meet our requirements. Therefore, it is more and more important to learn to solve the problem of rusting of these devices.

The following SBM teach users four solve crushing machinery rusting measures:

One, if it is found that the surface of metal crusher paint drop phenomenon, timely and then smear on the oxidation resistant paint;

Two, quarry crusher machine can use chemical descaling method, in the field of chemistry, acid can react with metal oxide, so this method can remove the broken machinery, metal surface oxide;

Impact of three, using high pressure water jet rust from metal surface to flush, the benefits of doing so is not damage the crusher equipment, and no dust pollution, but also can greatly improve the efficiency of derusting;

Four, can use electric derusting, major in electric or compressed air as a driving force, the assembly suitable descaling device, reciprocating or rotary motion, in order to adapt to the requirements of various occasions of rust.

Crushing plate crusher's out of the question, how to do?

Due to its quarry crusher nature of crushing equipment and working environment of the decision, crusher in runs daily may occur and the wear and tear on the case, then if the quarry crusher side guard plate and a crushing plate also appeared such questions, how should we correct solution can make it better for us service?

1, if the broken plate appeared to wear, so the crushed material is not up to our requirements, there will be time-consuming, laborious, energy consumption situation. At this point, we could adjust the size of a discharge port until we desired product size.

2, due to determine the motion characteristics of quarry crusher, thus the lower degree of wear broken board tended to be more severe than the upper. At this point, we can be broken board on the part of exchange the position so as to make it work better.

3, when the tooth peak crushing plate whet the height of 5 - 34, it is necessary to replace the broken of the new plate, if in two steps to repeat the above has no meaning.

4, if there is a local abrasion of teeth broken board, now we can adopt Di welding to repair.

5, if the broken plate fracture, will cause the jaw crusher can not work normally, you should replace the broken plate immediately.

来自 “ ITPUB博客 ” ，链接：http://blog.itpub.net/30047666/viewspace-1448172/，如需转载，请注明出处，否则将追究法律责任。

转载于:http://blog.itpub.net/30047666/viewspace-1448172/