This paper describes the use of self fall type
Concrete mixer should pay attention to when some of the items:
(1) before using new should be according to the concrete mixer specification, at the request of the system and parts inspection item by item and the necessary test run. Run idle, check the churn or mixing blade rotation direction, the working device operation, brake and confirm the normal, can work.
(2) stationary concrete mixer, should be installed in the firm on a pedestal. When use for a long time, should be buried real estate bolt; If short term use, can be in stand down laid sleeper and leveling put stability.
(3) for mobile concrete mixer, should be installed in the flat on the ground level ground of hard with square timber or bracket stand firm, and keep the water level tires don't stress. If you use time more than three months above, should will tire off safekeeping shaft end should do the clean rust prevention work.
(4) for some need to dig a pit in the hopper of the mixer, its around pithead should pad high compaction, in case of surface water flows into the pit. Feeding track frame. the bottom of the bearing surface should be compacted or tiles, the back of the rack should also use timber to support, to prevent work orbit deformation.
(5) concrete mixer start, should make churn to normal speed after feeding, feeding soon after adding water; Add new material must first will mixer original concrete after discharged all can. Not midway stop or full load when starting mixer, reverse discharging except the one.
(6) in the concrete mixer in use, do not make sand fall into the machine parts, lest make moving part stuck damage. Improve the hopper, the bucket down can't someone through or stay, in order to avoid brake failure accidents. As will be in the bucket down maintenance or cleaning work, forced outage and the hopper with insurance chain pull up.
来自 “ ITPUB博客 ” ,链接:http://blog.itpub.net/28646029/viewspace-754254/,如需转载,请注明出处,否则将追究法律责任。
转载于:http://blog.itpub.net/28646029/viewspace-754254/