usb口

USB On-The-Go connectors[edit]

A USB On-The-Go device is required to have one, and only one USB connector: a Micro-AB receptacle. This receptacle is capable of accepting both Micro-A and Micro-B plugs, attached to any of the legal cables and adapters as defined in Micro-USB1.01.

The OTG device with the A-plug inserted is called the A-device and is responsible for powering the USB interface when required and by default assumes the role of host. The OTG device with the B-plug inserted is called the B-device and by default assumes the role of peripheral. An OTG device with no plug inserted defaults to acting as a B-device. If an application on the B-device requires the role of host, then the Host Negotiation Protocol (HNP) is used to temporarily transfer the host role to the B-device.

OTG devices attached either to a peripheral-only B-device or a standard/embedded host have their role fixed by the cable, since in these scenarios it is only possible to attach the cable one way.^{[citation needed]}

Host and Device interface receptacles[edit]

The following receptacles accept the following plugs (note that all pin numbers as shown are as per plug; for receptacles numbers as shown are looking from the back out the front; a more typical manufacturer's "top" view into the receptacle would show the pin numbers as mirrored):

Receptacle (images not to scale)	Plug (images not to scale)
	Yes	No	No	No	No
	No	Yes	No	No	No
	No	No	Yes	No	No
	No	No	No	Yes	Yes
	No	No	No	No	Yes

Cable plugs (USB 1.x/2.0)[edit]

Cables exist with pairs of plugs:

Plug (images not to scale)	Plug (images not to scale)
	Non-standard	Yes	Yes	Non-standard	Yes
	Yes	No	No	Non-standard	No
	Yes	No	Non-standard	Non-standard	No
	Non-standard	Non-standard	Non-standard	No	Yes
	Yes	No	No	Yes	No