wlcore: firmware chunk too long

insmod wlcore_sdio.ko 的时候出现的错误

43.767890] Powering on wl12xx

[  143.846003] Powering off wl12xx

[  143.849249] Powering on wl12xx

[  143.949008] wlcore: ERROR could not get configuration binary ti-connectivity/wl18xx-conf.bin: -2

[  143.960629] wlcore: WARNING falling back to default config

[  143.967443] add wake up source irq 108

[  144.292965] Powering off wl12xx

[  144.319907] wlcore: loaded

[  144.325471] wlcore: driver version:

[  144.332153] wlcore: timestamp: Mon May 25 19:56:12 2015

[  228.991855] Powering on wl12xx

[  229.329532] wlcore: firmware chunk too long: 1731433

[  229.334802] Powering off wl12xx

[  229.361806] Powering on wl12xx

[  229.653852] wlcore: firmware chunk too long: 1731433

[  229.659057] Powering off wl12xx

[  229.691803] Powering on wl12xx

[  229.983832] wlcore: firmware chunk too long: 1731433

[  229.989046] Powering off wl12xx

[  229.992057] wlcore: ERROR firmware boot failed despite 3 retries

[  250.011866] Powering on wl12xx

[  250.305219] wlcore: firmware chunk too long: 1731433

[  250.310490] Powering off wl12xx

[  250.341847] Powering on wl12xx

[  250.635159] wlcore: firmware chunk too long: 1731433

[  250.640424] Powering off wl12xx

[  250.671848] Powering on wl12xx

[  250.963833] wlcore: firmware chunk too long: 1731433

[  250.969041] Powering off wl12xx

[  250.972052] wlcore: ERROR firmware boot failed despite 3 retries

看了一下，原来都不会出现固件太大uc问题，估计是拷贝固件的时候固件的数据出错导致

的

后面对比了一下固件。发现真的是不一样了。 所以重新拷贝了下就可以了。

 

转载于:https://www.cnblogs.com/ioio/p/4536590.html