总结了一下思科认证CCNA part的一些排错命令,不好之处,请指正,谢谢!
1.Cisco设备管理
Show arp Show clock Show version Show flash: //查看硬盘大小 Show running-config Show startup-config Show ip interface brief
Show interface f0/0
2.静态路由
Show ip route debug ip icmp undebug ip icmp undebug all //关闭所有调试 一般简写为“un all Clearp arp debug arp
3.RIP
Show ip route //查看路由表 Show ip route rip//查看RIP路由
Show run | section router rip //查看RIP配置 Show run | s r r //查看RIP配置
Show ip protocol //查看路由协议信息 clear ip route * //刷新路由表
4.EIGRP
Sh ip ei to Sh ip route ei Sh ip ei
5.OSPF
Sh ip ospf nei sh ip ospf data sh ip route ospf Clear ip ospf process//清除ospf 进程,重建邻居
6.交换基础
Show vlan-sw Show interface vlan X Show interface trunk show vtp status
Show spanning-tree interface fx/x Show spanning-tree brief
Show spanning-tree uplinkfast Show spanning-tree backbonefast
DHCP Show run | s ip dhcP Show ip dhcp binding Show ip dhcp pool show ethernet summary
port-security Show mac-address-table show port-security
7.广域网技术
Show int s0/0 PPP: Show interface multilink 1 show fram rou
show fram map ACL show int fx
Show ip nat translation Debug ip nat (观看运行过程的转换)