x264 pass 2缓存文件的使用

e += sscanf( p, " in:%*d out:%*d type:%c dur:%"SCNd64" cpbdur:%"SCNd64" q:%f aq:%f tex:%d mv:%d misc:%d imb:%d pmb:%d smb:%d d:%c",

                  &pict_type, &rce->i_duration, &rce->i_cpb_duration, &qp_rc, &qp_aq, &rce->tex_bits,

                  &rce->mv_bits, &rce->misc_bits, &rce->i_count, &rce->p_count,

                  &rce->s_count, &rce->direct_mode );

           rce->tex_bits  *= res_factor_bits;

           rce->mv_bits   *= res_factor_bits;

           rce->misc_bits *= res_factor_bits;

           rce->i_count   *= res_factor;

           rce->p_count   *= res_factor;

           rce->s_count   *= res_factor;

1 读取配置文件

for( int i = 0; i < rcc->num_entries; i++ )

   {

       ratecontrol_entry_t *rce = &rcc->entry[i];

       all_const_bits += rce->misc_bits;

   }

 

   if( all_available_bits < all_const_bits)

   {

       x264_log( h, X264_LOG_ERROR, "requested bitrate is too low. estimated minimum is %d kbps\n",

                (int)(all_const_bits * rcc->fps / (rcc->num_entries * 1000.)) );

       return -1;

   }

 

2 遍历所有的缓存信息，对msic_bits求和，看是否大于要求的码率，如果大于，则异常。

 

 

3 先是循环计算每一帧的复杂度

 

4 然后找到一个合适的rate_factor最终把码率编码在预期的范围内。