本文详细介绍了如何通过UART接口烧写uboot。首先，确保EVM设置为UART启动模式。在看到'CCCC'字符后，使用TeraTerm通过XMODEM和YMODEM分别传输u-boot-spl.bin和u-boot.img。遇到错误时，需在5个C前开始传输以确保成功。进入U-Boot提示符后，执行特定命令将SPL(MLO)和U-Boot映像写入NAND闪存，完成持久存储。
The release package does not contain thebinary for UART boot. Please follow the steps mentioned here for compiling u-bootand use the spl/u-boot-spl.bin file that
is produced.（已有文件u-boot-spl.bin，u-boot.img，MLO）
Switch ON EVM with switch settings for UARTboot.
When “CCCC” characters appear on TeraTerm window, from the File Menu select Transfer --> XMODEM --> Send (1Kmode)
Select “u-boot-spl.bin” for the transfer
After image is successfully downloaded, theROM code will boot it.
When “CCCC” characters appear on TeraTermwindow, from the File Menu select Transfer --> YMODEM --> Send (1Kmode)
Select “u-boot.img” for the transfer
After image is successfully downloaded,U-Boot will boot it.
（一开始使用超级终端SecureCRT 7.2，在传输u-boot-spl
最低0.47元/天 解锁文章
4357
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
