1.下载zookeeper-3.4.6.tar.gz 下载地址 http://archive.apache.org/dist/zookeeper/zookeeper-3.4.6/
2.下载完解压 tar zxvf zookeeper-3.4.6.tar.gz
3.进入zookeeper-3.4.6 下 cd zookeeper-3.4.6
4.创建两个文件夹 data ,logs mkdir data
5.进入到conf文件夹下 拷贝zoo_sample.cfg 为zoo.cfg
修改 zoo.cfg内容如下 其实就是下图中圈的地方。 注意要加root,绝对路径,路径错了,服务会有问题的
# The number of milliseconds of each tick
tickTime=2000
# The number of ticks that the initial
# synchronization phase can take
initLimit=10
# The number of ticks that can pass between
# sending a request and getting an acknowledgement
syncLimit=5
# the directory where the snapshot is stored.
# do not use /tmp for storage, /tmp here is just
# example sakes.
dataDir=/root/zookeeper-3.4.6/data
dataLogDir=/root/zookeeper-3.4.6/logs
# the port at which the clients will connect
clientPort=2181
# the maximum number of client connections.
# increase this if you need to handle more clients
#maxClientCnxns=60
#
# Be sure to read the maintenance section of the
# administrator guide before turning on autopurge.
#
# http://zookeeper.apache.org/doc/current/zookeeperAdmin.html#sc_maintenance
#
# The number of snapshots to retain in dataDir
#autopurge.snapRetainCount=3
# Purge task interval in hours
# Set to "0" to disable auto purge feature
#autopurge.purgeInterval=1
6.启动服务 进入bin目录 ,zkServer.sh start 启动服务。
查看服务启动状态 zkServer.sh status 显示 mode:standalone就表示成功了。