REXROTH HMS01.1N-W0150-A-07-NNNN 仅在运行期间检测到此错误

REXROTH HMS01.1N-W0150-A-07-NNNN 仅在运行期间检测到此错误 

控制处于非操作模式伺服链路变量：服务：状态错误-报警。非操作模式（91）ProAct处于非操作模式。当装置处于调整用户停止模式、配置模式、测试模式或校准模式时，报警启用，当条件为假时，报警禁用。代码：92：检测到软件错误Servlink变量：服务：状态错误--报警。软件错误（92）检测到软件错误。当检测到内部软件编码错误时，将启用报警。安装的软件应用程序无效，需要重新安装才能清除此故障。（建议将装置返回工厂以安装此新软件应用程序。）代码：93:EEPROM错误Servlink变量：服务：状态错误--报警。EEPROM错误（93）此警报与初始化期间检测到的EEPROM错误（代码02）相同，仅在运行期间检测到此错误。与将机组保持在停机状态相反，当检测到该错误时，机组将保持在运行状态。尝试的EEPROM更改将不会进行，但该装置将保持运行，并将更改保存在RAM中。然而，下一次通电将导致这些更改的丢失和/或可能在通电时出现EEPROM错误，从而导致非操作状态。

CODE: 86 : A/D Reference Error Servlink Variable: Service:Status Error – Alarms. A/D Reference Error (86) This is caused by faulty hardware. The 5.0 V A/D precision reference voltage is out of range. This is determined to be true if all voltage measurements are off (24 V input power, 12 V, 5 V and –9 V). CODE: 91 : Control is in a Non-Operating Mode Servlink Variable: Service:Status Error—Alarms. NonOperating Mode (91) The ProAct is in a non-operating mode. The alarm is enabled when the unit is in the Adjust User Stops Mode or Configure Mode or Test Mode or Calibration Mode and is disabled when the conditions go false. CODE: 92 : Software Error detected Servlink Variable: Service:Status Error—Alarms. Software Error (92) A software error has been detected. The alarm is enabled when an internal software coding error detected. The installed software application is invalid and will need to be reinstalled to clear this fault. (It is advisable to return the unit to the factory to have this new software application installed.)