原创作者:运维工程师 谢晋
网卡绑定bond0的实现
查看系统版本
# cat /etc/redhat-release
CentOS Linux release 7.9.2009 (Core)
VMware虚拟机添加一块新网卡
可以看到新加了一块网卡(DHCP自动获取到了地址)
配置物理网卡
# cat ifcfg-eth0
NAME=eth0
DEVICE=eth0
BOOTPROTO=none
MASTER=bond0
SLAVE=yes
ONBOOT=yes
# cat ifcfg-eth1
NAME=eth1
DEVICE=eth1
BOOTPROTO=none# cat ifcfg-bond0
NAME=bond0
TYPE=bond
DEVICE=bond0
BOOTPROTO=none
IPADDR=192.168.20.132
PREFIX=24
GATEWAY=192.168.20.1
DNS1=114.114.114.114
BONDING_OPTS="mode=1 miimon=100 fail_over_mac=1"
MASTER=bond0
SLAVE=yes
ONBOOT=yes
加载bond0
# systemctl restart network.service
# modprobe bonding
查看bond0状态
# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)
Bonding Mode: fault-tolerance (active-backup) (fail_over_mac active)
Primary Slave: None
Currently Active Slave: eth0
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 0
Down Delay (ms): 0
Slave Interface: eth0
MII Status: up
Speed: 10000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:50:56:9c:6f:82
Slave queue ID: 0
Slave Interface: eth1
MII Status: up
Speed: 10000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:50:56:9c:a4:9a
Slave queue ID: 0
查看IP
# ifconfig
bond0: flags=5187<UP,BROADCAST,RUNNING,MASTER,MULTICAST> mtu 1500
inet 192.168.20.132 netmask 255.255.255.0 broadcast 192.168.20.255
inet6 fe80::250:56ff:fe9c:6f82 prefixlen 64 scopeid 0x20<link>
ether 00:50:56:9c:6f:82 txqueuelen 1000 (Ethernet)
RX packets 121 bytes 10200 (9.9 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 76 bytes 10536 (10.2 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
测试
关闭一张网卡IP仍然能通信