第八步: 停止主集群,配置容灾参数,重新拉起主集群
cm_ctl stop
主节点
gs_guc set -N node1 -D /opt/mpp/install/data/dn -c "application_name = 'dn_master_0'"
gs_guc set -N node1 -D /opt/mpp/install/data/dn -c "cross_cluster_replconninfo1='localhost=10.0.0.10 localport=25400 remotehost=20.0.0.10 remoteport=25400'"
gs_guc set -N node1 -D /opt/mpp/install/data/dn -c "cross_cluster_replconninfo2='localhost=10.0.0.10 localport=25400 remotehost=20.0.0.20 remoteport=25400'"
gs_guc set -N node1 -D /opt/mpp/install/data/dn -c "ha_module_debug = off"
gs_guc set -N node1 -D /opt/mpp/install/data/dn -h "host all all 20.0.0.10/32 trust"
gs_guc set -N node1 -D /opt/mpp/install/data/dn -h "host all all 20.0.0.20/32 trust"
备节点
gs_guc set -N node2 -D /opt/mpp/install/data/dn -c "application_name = 'dn_master_1'"
gs_guc set -N node2 -D /opt/mpp/install/data/dn -c "cross_cluster_replconninfo1='localhost=10.0.0.20 localport=25400 remotehost=20.0.0.10 remoteport=25400'"
gs_guc set -N node2 -D /opt/mpp/install/data/dn -c "cross_cluster_replconninfo2='localhost=10.0.0.20 localport=25400 remotehost=20.0.0.20 remoteport=25400'"
gs_guc set -N node2 -D /opt/mpp/install/data/dn -c "ha_module_debug = off"
gs_guc set -N node2 -D /opt/mpp/install/data/dn -h "host all all 20.0.0.10/32 trust"
gs_guc set -N node2 -D /opt/mpp/install/data/dn -h "host all all 20.0.0.20/32 trust"
设置主集群cm参数
cm_ctl set --param --agent -k ss_double_cluster_mode=1
启动主集群
cm_ctl start
参数解释:
- cross_cluster_replconninfo 主备集群建立连接信息,localport为数据库HA端口(上述示例用的xml里的dataPortBase,当开启线程池enable_thread_pool时,需配置为实际HAPort)
Tips
: gs_guc为openGauss提供的修改配置文件工具,也可以通过直接打开/opt/huawei/install/data/dn($PGDATA)下的postgresql.conf与pg_hba.conf文件将上面双引号中的内容手动写入文件中。
详情查看:https://opengauss.org
详情查看:https://docs-opengauss.osinfra.cn