ifconfig: SIOCSIFFLAGS: Cannot assign requested address

Linux昨天晚上终于跑起来了，文件系统也可以用了，我在开机时调用ifconfig设置进行IP地址的设置，可是总是会显示：ifconfig: SIOCSIFFLAGS: Cannot assign requested address很纳闷，网上查了一下，原来是MAC地址的问题，经过以下的处理，就OK啦~# ifconfig eth0 down
# ifconfig eth0 hw ether 00:00:AA:BB:CC:DD
# ifconfig eth0 up
eth0: link down
# ifeth0: link up, 100Mbps, full-duplex, lpa 0xCDE1
       
# ifconfig eth0
eth0     Link encap:Ethernet HWaddr 00:00:AA:BB:CC:DD 
          inet addr:192.168.1.70 Bcast:192.168.1.255 Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
          RX packets:11 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:1104 (1.0 KiB) TX bytes:0 (0.0 B)
          Interrupt:51 Base address:0xe300# ifconfig eth0 192.168.2.17
# ifconfig
eth0     Link encap:Ethernet HWaddr 00:00:AA:BB:CC:DD 
          inet addr:192.168.2.17 Bcast:192.168.2.255 Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
          RX packets:46 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:6967 (6.8 KiB) TX bytes:0 (0.0 B)
          Interrupt:51 Base address:0xe300# ping 192.168.2.80
PING 192.168.2.80 (192.168.2.80): 56 data bytes
64 bytes from 192.168.2.80: seq=0 ttl=128 time=4.852 ms
64 bytes from 192.168.2.80: seq=1 ttl=128 time=1.134 ms
64 bytes from 192.168.2.80: seq=2 ttl=128 time=1.020 ms