交换机命令,路由器命令

 

http://10.10.90.1:8888

用户名：quidway

 

交换机命令：

<AL3SW1>system-view                                //进入系统视图

[AL3SW1]Ctrl+Z                                      //进入用户视图

[AL3SW1]sysname h3c                                 //交换机命名

[AL3SW1]display version                               //显示交换机版本

[AL3SW1]display vlan 1                                //查看vlan设置

[AL3SW1]display interface                             //显示接口信息

[AL3SW1]display current-configuration                   //显示交换机当前运行的配置

[AL3SW1]inter e1/0/1                                  //进入以太网口视图

[AL3SW1-e1/0/1]port link-type trunk                      //设置以太网口工作模式

[AL3SW1-e1/0/1]port trunk permit vlan 1                  //设置trunk允许的vlan

[AL3SW1]inter s5/0                                    //进入串口视图

[AL3SW1-s5/0]ip address 10.10.90.17 255.255.255.0          //配置串口IP地址

[AL3SW1-s5/0]shutdown                                //关闭端口

[AL3SW1-s5/0]undo shutdown                           //激活端口

[AL3SW1]vlan 1                                      //创建vlan

[AL3SW1-vlan1]port e1/0/1 to e1/0/4                      //在vlan中添加端口

[AL3SW1-vlan1]quit                                   //退出

[AL3SW1]inter vlan 1                                  //进入vlan接口视图

[AL3SW1-Vlan-inter1]ip address 10.10.90.7 255.255.255.0    //配置vlan的IP地址

<AL3SW1>reboot                                      //重启交换机

 

 

路由器命令：

[ARouter1]display ip routing-table                        //显示路由表信息

[ARouter1]inter gi0/0                                  //进入吉比特以太网口视图

[ARouter1-gi0/0]ip address 192.168.1.1 24                 //配置吉比特以太网口IP地址

[ARouter1]inter s5/0                                   //进入串口视图

[ARouter1-s5/0]ip address 10.10.90.2 30                    //配置串口IP地址

[ARouter1]rip                                        //设置动态路由

[ARouter1]rip work                                   //设置工作允许

[ARouter1-rip]network 10.10.90.6                       //设置交换路由的网络

< ARouter1>reboot                                    //重启路由器