MPLS借用动态lsp传输新的路由配置

拓扑如图：

直接上配置吧：

R1配置：

sys
#
 sysname R1
#

mpls lsr-id 10.10.1.1
mpls
#
mpls ldp
#

isis 1
 network-entity 49.0001.0000.0000.0001.00
#
interface GigabitEthernet0/0/0
 ip address 10.12.1.1 255.255.255.0 
 isis enable 1
 mpls
 mpls ldp
#
interface LoopBack0
 ip address 10.10.1.1 255.255.255.255 
 isis enable 1
#
interface LoopBack1
 ip address 10.10.10.1 255.255.255.255 
#
ip route-static 10.10.10.3 255.255.255.255 10.12.1.2
#
static-lsp ingress R1 destination 10.10.10.3 32 nexthop 10.12.1.2 out-label 1025
#
return
#

R2配置：

sys
#
 sysname R2
#
mpls lsr-id 10.10.1.2
mpls
#
mpls ldp
#
isis 1
 network-entity 49.0001.0000.0000.0002.00
#
interface GigabitEthernet0/0/0
 ip address 10.12.1.2 255.255.255.0 
 isis enable 1
 mpls
 mpls ldp
#
interface GigabitEthernet0/0/1
 ip address 10.23.1.2 255.255.255.0 
 isis enable 1
 mpls
 mpls ldp
#
interface LoopBack0
 ip address 10.10.1.2 255.255.255.255 
 isis enable 1
#
return
#

R3配置：

sys
#
 sysname R3
#
mpls lsr-id 10.10.1.3
mpls
#
mpls ldp
#
isis 1
 network-entity 49.0001.0000.0000.0003.00
#
interface GigabitEthernet0/0/0
 ip address 10.23.1.3 255.255.255.0 
 isis enable 1
 mpls
 mpls ldp
#
interface LoopBack0
 ip address 10.10.1.3 255.255.255.255 
 isis enable 1
#
interface LoopBack1
 ip address 10.10.10.3 255.255.255.255 
#
ip route-static 10.10.10.1 255.255.255.255 10.23.1.2
#
static-lsp ingress R3 destination 10.10.10.1 32 nexthop 10.23.1.2 out-label 1024
#
return
#

在R1上ping -a 10.10.10.1 10.10.10.3   

----------------------------------------------------------对网络感兴趣的朋友可以加我微信：【piaofeng0129】一起交流讨论。