1、
bash-3.00# hostname
tianyu
bash-3.00# pwd
/etc
bash-3.00# vi hosts
"hosts" [Read only] 5 lines, 76 characters
#
# Internet host table
#
127.0.0.1 localhost
192.168.1.119 tianyujiajia loghost
2、
bash-3.00# vi hostname.e1000g0
"hostname.e1000g0" 1 line, 7 characters
tianyujiajia
3、
bash-3.00# vi nodename
"nodename" 1 line, 7 characters
tianyujiajia
~
4、重启 init 6
5、检查已经修改成功
-bash-3.00$ hostname
tianyujiajia
-bash-3.00$
Solaris 10修改网卡IP地址
修改前IP
bash-3.00# ifconfig -a
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232 index 1
inet 127.0.0.1 netmask ff000000
e1000g0: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 2
inet 192.168.1.119 netmask ffffff00 broadcast 192.168.1.255
ether 0:c:29:11:af:6c
1、
bash-3.00# vi hosts
"hosts" [Read only] 5 lines, 82 characters
#
# Internet host table
#
127.0.0.1 localhost
192.168.1.118 tianyujiajia loghost
2、
bash-3.00# pwd
/etc/inet
bash-3.00# vi ipnodes
"ipnodes" [Read only] 6 lines, 91 characters
#
# Internet host table
#
::1 localhost
127.0.0.1 localhost
192.168.1.118 tianyu loghost
3、
bash-3.00# pwd
/etc
bash-3.00# vi netmasks ---由于此次修改的IP和以前是同网段的,所以这里的文件可以不需要修改
"netmasks" [Read only] 15 lines, 382 characters
#
# The netmasks file associates Internet Protocol (IP) address
# masks with IP network numbers.
#
# network-number netmask
#
# The term network-number refers to a number obtained from the Internet Network
# Information Center.
#
# Both the network-number and the netmasks are specified in
# "decimal dot" notation, e.g:
#
# 128.32.0.0 255.255.255.0
#
192.168.1.0 255.255.255.0
4、
bash-3.00# pwd
/etc
bash-3.00# vi defaultrouter ---由于此次修改的IP和以前是同网段的,所以这里的文件可以不需要修改
"defaultrouter" 1 line, 14 characters
192.168.1.254
5、重启init 6
修改后IP
bash-3.00# ifconfig -a
lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232 index 1
inet 127.0.0.1 netmask ff000000
e1000g0: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 2
inet 192.168.1.118 netmask ffffff00 broadcast 192.168.1.255
ether 0:c:29:11:af:6c