编译安装参数如下:
./configure \
--prefix=/usr/local/php \
--with-apxs2=/usr/local/apache2/bin/apxs \
--with-config-file-path=/usr/local/php/etc \
--with-mysql=/usr/local/mysql/ \
--with-libxml-dir \
--with-gd \
--with-jpeg-dir \
--with-png-dir \
--with-freetype-dir \
--with-iconv-dir \
--with-zlib-dir \
--with-bz2 \
--with-openssl \
--with-mcrypt \
--enable-soap \
--enable-gd-native-ttf \
--enable-mbstring \
--enable-sockets \
--enable-exif \
--disable-ipv6
遇到的错误如下:
Sorry, I cannot run apxs. Possible reasons follow:
1. Perl is not installed
2. apxs was not found. Try to pass the path using –with-apxs2=/path/to/apxs
3. Apache was not built using –enable-so (the apxs usage page is displayed)
The output of /usr/local/apache/bin/apxs follows:
./configure: /usr/local/apache/bin/apxs: not found
configure: error: Aborting
解决方法如下:
找到apache目录下的apxs脚本文件,然后编辑它,把第一行的注释的地方修改为perl的可执行路径(首先要保证你安装过perl,没有安装请先行安装),如
yum install perl perl-devel
vi /usr/local/apache2/bin/apxs
#!/usr/bin/perl -w ####原来为 /replace/with/path/to/perl/interpreter