-
- 题目要求
- 左边做单臂路由,SW3为纯二层交换机,SW2为三层交换机,PC1能访问PC3使用静态路由
- 操作
- 配置IP地址/网关给主机\将每个接口IP先进行划分配置
- PC1 1.1.1.1 24 WG 1.1.1.254
- PC2 2.2.2.2 24 WG 2.2.2.254
- PC3 3.3.3.3 24 WG 3.3.3.254
- SW1配置信息
- interface GigabitEthernet0/0/1
- port link-type access
- port default vlan 10
- #
- interface GigabitEthernet0/0/2
- port link-type access
- port default vlan 20
- #
- interface GigabitEthernet0/0/3
- port link-type trunk
- port trunk allow-pass vlan 10 20
- AR10(完成之后查看路由表;优先级一样)
- interface GigabitEthernet0/0/0.1
- dot1q termination vid 10
- ip address 1.1.1.254 255.255.255.0
- arp broadcast enable
- #
- interface GigabitEthernet0/0/0.2
- dot1q termination vid 20
- ip address 2.2.2.254 255.255.255.0
- arp broadcast enable
- #
- interface GigabitEthernet0/0/1
- ip address 4.4.4.1 255.255.255.0
- ip route-static 3.3.3.0 255.255.255.0 4.4.4.2
- #
- SW2
- vlan batch 10 30
- #
- interface Vlanif10
- ip address 4.4.4.2 255.255.255.0
- #
- interface Vlanif30
- ip address 3.3.3.254 255.255.255.0
- #
- interface MEth0/0/1
- #
- interface GigabitEthernet0/0/1
- port link-type access
- port default vlan 10
- #
- interface GigabitEthernet0/0/2
- port link-type trunk
- port trunk allow-pass vlan 30
- #
- ip route-static 1.1.1.0 255.255.255.0 4.4.4.1
- SW3
- vlan batch 30
- #
- interface MEth0/0/1
- #
- interface GigabitEthernet0/0/1
- port link-type trunk
- port trunk allow-pass vlan 30
- #
- interface GigabitEthernet0/0/2
- port link-type access
- port default vlan 30
- 配置IP地址/网关给主机\将每个接口IP先进行划分配置
单臂路由配置
最新推荐文章于 2024-06-14 23:06:21 发布