E-trunk+Eth-trunk模拟实验（ENSP）

E-trunk是跨设备的链路聚合，基于LACP进行了扩展，链路可靠性从单板级提高到了设备级，常用与CE双归接入PE1和PE2。

E-trunk配置示例：

 

 

 1、SW2和SW3配置三层接口，能互相通信

sw2：

interface Vlanif100
ip address 10.1.1.1 255.255.255.0
interface GigabitEthernet0/0/3
 port link-type trunk
 port trunk allow-pass vlan 100

sw3：

interface Vlanif100
ip address 10.1.1.2 255.255.255.0
interface GigabitEthernet0/0/3
 port link-type trunk
 port trunk allow-pass vlan 100

2、sw1、sw2、sw3、sw4配置eth-trunk，并将相应的接口绑定到eth-trunk

[sw1]interface Eth-Trunk 10
mode lacp-static                   //要配置模式为静态，而且要先设置模式再绑定端口
trunkport GigabitEthernet 0/0/1 to 0/0/4


[sw2]interface Eth-Trunk 20
mode lacp-static
trunkport GigabitEthernet 0/0/1
trunkport GigabitEthernet 0/0/2
[sw2]interface Eth-Trunk 24        //sw2与sw4之间创建eth-trunk24
mode lacp-static                   
trunkport GigabitEthernet 0/0/4 
trunkport GigabitEthernet 0/0/5

[sw3]interface Eth-Trunk 30
mode lacp-static
trunkport GigabitEthernet 0/0/1
trunkport GigabitEthernet 0/0/2
[sw2]interface Eth-Trunk 34        //sw3与sw4之间创建eth-trunk34
mode lacp-static                   
trunkport GigabitEthernet 0/0/4 
trunkport GigabitEthernet 0/0/5

[sw4]int Eth-Trunk 40
mode lacp-static                   
trunkport GigabitEthernet 0/0/1 to 0/0/4

在各交换机上查看eth-trunk是否正常，示例sw1

[sw1]dis eth-trunk 10
Eth-Trunk10's state information is:
Local:
LAG ID: 10                  WorkingMode: STATIC                               
Preempt Delay: Disabled     Hash