MU-MIMO测试吞吐方法
Test topology
• Use a MU-MIMO AP (for example, Linksys EA8500) with the latest image
Note: Use the latest image on AP.
• A control PC for the AP supports Gigabit Ethernet, either iperf or licensed IxChariot
• All STAs (support either 1x1 or 2x2) have iperf or IxChariot endpoint environment
Note: Download the iPerf or IxChariot application from Playstore
• Maintain 1 or 3 m away from AP to all STAs, and 1 m away between STAs
• AP and STAs are placed in isolated chambers or an open environment
Test procedure
- Enable AP with 5 GHz, 80 MHz, and WPA2 (open) security.
- Make sure MU-MIMO is enabled on AP and STAs by default.
- Associate STAs with AP.
- Run UDP DL and TCP DL peak TPUT between AP to STAs, simultaneously, on all STAs.
- Capture the throughputs on the STAs (Rx).
- Aggregate the throughput observed on all the STAs.
- Compare the results with MU-MIMO disabled.
• Disable MU-MIMO mode from AP (or STA).
• MU-MIMO gain = (MU-MIMO-enabled throughput)/(MU-MIMO disabled throughput).
Beacon Frame
Assoc Req Frame
MU gain in controlled environment (VHT80)
1SS + 1SS
UDP 1.74
TCP 1.72
1SS + 1SS + 1SS
UDP 2.43
TCP 2.32
2SS + 1SS
UDP 1.71
TCP 1.70
2SS + 2SS
UDP 1.29
TCP 1.23
2SS + 2SS + 2SS
UDP 1.21
TCP 1.14