使用开发板作为PC contoller

https://community.silabs.com/s/article/z-wave-700-otw-of-controller

1. Erase the board
2. Program Bootloader

There are two pre-compiled OTW bootloader files available in Z-Wave SDK for ZGM130S module and EFR32ZG14, respectively.

\protocol\z-wave\Apps\bin\

OTW-bootloader-fg13-combined.s37

 OTW-bootloader-fg14-combined.s37

1. Program relative SerialAPI Controller Firmware , which should be the same as bootloader

Z-Wave SDK contains pre-compiled SerialAPI controller binaries for both ZGM130S module and EFR32ZG14.

\protocol\z-wave\Apps\bin\

ZW_SerialAPI_Controller_*_ZGM130S_REGION_*.hex
ZW_SerialAPI_Controller_*_EFR32ZG14_REGION_*.hex

1. Program the keys : You can use the key under \protocol\z-wave\BootLoader\sample-keys\ or the keys which you create.

1. Reset device , after this you can use jLink io to control your development board as PC controller