Check Cisco Device Interface Throughput with load-interval Command

最新推荐文章于 2023-07-27 01:15:00 发布

net sec

最新推荐文章于 2023-07-27 01:15:00 发布

阅读量208

点赞数

本文链接：https://blog.csdn.net/netsec51sec/article/details/98956840

版权

BGP_1#sh int g0/1
GigabitEthernet0/1 is up, line protocol is up
Hardware is iGbE, address is e02f.6d05.c401 (bia e02f.6d05.c401)
Internet address is 6.99.9.30/32
MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full Duplex, 1Gbps, media type is RJ45
output flow-control is unsupported, input flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of “show interface” counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 1463000 bits/sec, 530 packets/sec
5 minute output rate 2452000 bits/sec, 417 packets/sec
21277230 packets input, 3855639781 bytes, 0 no buffer
Received 716 broadcasts (0 IP multicasts)

Check “load” numbers. These are defaulted to a rolling average of 5 minutes and displayed as a factor of 255 (2^8, but counting from 0 not one). So a load of 255/255 would be completely saturated.

You can change this 5 minute default to a 30 second rolling average by going to the interface in question and issuing the command “load-interval 30” This a very useful process when deploying BGP. The tx/rx of course is transmit load versus receive load, which can also be extremely handy in understanding certain traffic issues (BGP load sharing for example).

BGP_1#sh run int g0/1

Building configuration…

Current configuration : 179 bytes

interface GigabitEthernet0/1

description Link with Cogeco BGP

ip address 6.99.9.30 255.255.255.255

load-interval 30

duplex auto

speed auto

end

BGP_1#show interfaces g0/1

GigabitEthernet0/1 is up, line protocol is up