周星星_少年只有一个面的博客

开发过程中发现Vin 超过 3.85v，蓝牙连接不稳定。反馈脚与Vout之间添加一个 5nf电容。

/* Delete Ad Type Tx Power */ ret = aci_gap_delete_ad_type(AD_TYPE_TX_POWER_LEVEL); if(BLE_STATUS_SUCCESS == ret) { APP_DBG_MSG("Successfully Delete Tx Power \n" ); } else { APP_DBG_MSG("Delete Tx Power Fail\n" ); }

广播间隔以0.625ms为单位。app_conf.h#define CFG_FAST_CONN_ADV_INTERVAL_MIN (0x80) /**< 80ms */#define CFG_FAST_CONN_ADV_INTERVAL_MAX (0xa0) /**< 100ms */#define CFG_LP_CONN_ADV_INTERVAL_MIN (0x640) /**< 1s */#define CFG_LP_CONN_ADV_INTERV

1、调用aci_gatt_exchange_config这个api可以产生mtu交互事件。/** * @brief Perform an ATT MTU exchange procedure.When the ATT MTU exchange procedure is completed, a @ref aci_att_exchange_mtu_resp_eventevent is generated. A @ref aci_gatt_proc_complete_event event is a

/* Update Scan data */ { uint8_t scan_data[31] = { 0x14,/*len = 1(ad type) + 2 (manuf id) + x(payload data)*/ AD_TYPE_MANUFACTURER_SPECIFIC_DATA,/*type*/ 0x7e, 0xff,/*manuf id*/ 0x00/*payload data*/ }; ret = hci_le_set_scan_response_data(

时钟配置外部高速晶振给晶振使用使能RTC中断使能RF使能BLEconfig添加代码修改广播名测试查看用nrf connect查看

使能log// <e> NRF_LOG_ENABLED - nrf_log - Logger//==========================================================#ifndef NRF_LOG_ENABLED#define NRF_LOG_ENABLED 0//1#endif// <h> Log message pool - Configuration of log message pool使能RTT// <

STM32WB55rgv6STM32_Programmer_CLI.exe -c port=SWD mode=HOTPLUG -r32 0x20030000 4