nRF PWM配置注意事项

/* 1-channel PWM, 2700Hz, output on BUZZER pins. */

app_pwm_config_t pwm1_cfg = APP_PWM_DEFAULT_CONFIG_1CH(365L, BUZZER_01);



/* Switch the polarity of the second channel. */

pwm1_cfg.pin_polarity[1] = APP_PWM_POLARITY_ACTIVE_LOW;



/* Initialize and enable PWM. */

err_code = app_pwm_init(&PWM1,&pwm1_cfg,pwm_ready_callback);

APP_ERROR_CHECK(err_code);

app_pwm_enable(&PWM1);

app_pwm_channel_duty_set(&PWM1, 0, 50);



APP_PWM_DEFAULT_CONFIG_1CH中第一个周期参数对应PWM波形频率。（默认5000L -> 对应200Hz）



app_pwm_channel_duty_set(&PWM1, 0, 50);表示占空比，即所选通道极性占比50％





nrf_gpio_pin_clear(BUZZER_01);

app_pwm_channel_duty_set(&PWM1, 0, 100);

app_pwm_disable(&PWM1);

/* Uninitialize and disenable PWM. */

err_code = app_pwm_uninit(&PWM1);

APP_ERROR_CHECK(err_code);

 

注：在关闭PWM时若想直接关闭（应用场景：无源蜂鸣器）：则首先要将电平置于关闭后再将占空比设为100％，而后失能及关闭PWM通道