【STM32G030F6】dma扫描读取ADC值不准确的解决办法

初始化后使用

HAL_ADCEx_Calibration_Start(&hadc1);

重新校准ADC电压

ADC_HandleTypeDef hadc1;

int main(void)
{
  /* USER CODE BEGIN 1 */

  /* USER CODE END 1 */

  /* MCU Configuration--------------------------------------------------------*/

  /* Reset of all peripherals, Initializes the Flash interface and the Systick. */
  HAL_Init();

  /* USER CODE BEGIN Init */

  /* USER CODE END Init */

  /* Configure the system clock */
  SystemClock_Config();

  /* USER CODE BEGIN SysInit */
 
  /* USER CODE END SysInit */

  /* Initialize all configured peripherals */
  MX_GPIO_Init();
  MX_DMA_Init();
  MX_ADC1_Init();

  HAL_Delay(200);
  HAL_ADCEx_Calibration_Start(&hadc1);

  MX_TIM1_Init();
  MX_TIM3_Init();
  MX_USART1_UART_Init();
  /* USER CODE BEGIN 2 */
 // HAL_Delay(200);
  //HAL_ADCEx_Calibration_Start(&hadc1);
  
   Parm_Init();  
  HAL_TIM_Base_Start_IT(&htim1); 
  /*开始定时器3*/
  HAL_TIM_Base_Start_IT(&htim3); 

  //串口1 DMA通道开启扫描
  HAL_UART_Receive_DMA(&huart1, (uint8_t *)RxBuffer1, rx1_num);
 
  /* USER CODE END 2 */

  /* Infinite loop */
  /* USER CODE BEGIN WHILE */
  while (1)
  {
    /* USER CODE END WHILE */

    /* USER CODE BEGIN 3 */

  }
  /* USER CODE END 3 */
}