记一次STM32F3单片机无法下程序解决方法

不知道什么操作导致keil5下载STM32F3的程序时报以下错误：

JLink info:
------------
DLL: V4.90 , compiled Jul 28 2014 10:35:20
Firmware: J-Link OB-STM32F072-CortexM compiled Mar  8 2020 11:15:54
Hardware: V1.00
Feature(s) : GDB, RDI, FlashBP, FlashDL, JFlash, RDDI 
 
* JLink Info: Found SWD-DP with ID 0x2BA01477
* JLink Info: Found Cortex-M4 r0p1, Little endian.
* JLink Info: FPUnit: 6 code (BP) slots and 2 literal slots
* JLink Info: TPIU fitted.
* JLink Info: ETM fitted.
ROMTableAddr = 0xE00FF003
**JLink Warning: Could not set S_RESET_ST
**JLink Warning: CPU did not halt after reset.
**JLink Warning: CPU could not be halted
* JLink Info: Core did not halt after reset, trying to disable WDT.
**JLink Warning: CPU did not halt after reset.
**JLink Warning: CPU could not be halted
**JLink Warning: Could not set S_RESET_ST
* JLink Info: Found SWD-DP with ID 0x2BA01477
* JLink Info: Found Cortex-M4 r0p1, Little endian.
**JLink Warning: Could not set S_RESET_ST
**JLink Warning: CPU did not halt after reset.
**JLink Warning: CPU could not be halted
* JLink Info: Core did not halt after reset, trying to disable WDT.
**JLink Warning: CPU did not halt after reset.
**JLink Warning: CPU could not be halted
**JLink Warning: Could not set S_RESET_ST
**JLink Warning: CPU could not be halted
Error: Flash Download failed  -  Target DLL has been cancelled
Flash Load finished at 14:40:01

 

错误原因：芯片进入休眠状态，故无法下载程序。

解决办法：硬件上电前，先将复位脚与3.3v短接，然后上电，点击下载，同时断开复位脚与3.3v，即可下载成功。亲测可用！