picocom使用方法

# ./picocom  /dev/ttySLB0
picocom version dev

port is        : /dev/ttySLB0
flowcontrol    : none
baudrate is    : 9600
parity is      : none
databits are   : 8
stopbits are   : 1
escape is      : C-a
local echo is  : no
noinit is      : no
noreset is     : no
hangup is      : no
nolock is      : no
send_cmd is    : sz -vv
receive_cmd is : rz -vv -E
imap is        : 
omap is        : 
emap is        : crcrlf,delbs,
logfile is     : none
initstring     : none
exit_after is  : not set
exit is        : no

Type [C-a] [C-h] to see available commands
Terminal ready

此处按Ctrl+a, Ctrl+h组合键

*** Picocom commands (all prefixed by [C-a])

*** [C-x] : Exit picocom
*** [C-q] : Exit without resetting serial port
*** [C-b] : Set baudrate
*** [C-u] : Increase baudrate (baud-up)
*** [C-d] : Decrease baudrate (baud-down)
*** [C-i] : Change number of databits
*** [C-j] : Change number of stopbits
*** [C-f] : Change flow-control mode
*** [C-y] : Change parity mode
*** [C-p] : Pulse DTR
*** [C-t] : Toggle DTR
*** [C-g] : Toggle RTS
*** [C-|] : Send break
*** [C-c] : Toggle local echo
*** [C-w] : Write hex
*** [C-s] : Send file
*** [C-r] : Receive file
*** [C-v] : Show port settings
*** [C-h] : Show this message

此处按Ctrl+a, Ctrl+b组合键，然后输入波特率

*** baud: 115200

*** baud: 115200 ***

此处按Ctrl+a, Ctrl+i 组合键，多次按Ctrl+a, Ctrl+i 组合键，databits在5、6、7、8之间切换。

*** databits: 5 ***

*** databits: 6 ***

*** databits: 7 ***

*** databits: 8 ***

此处按Ctrl+a, Ctrl+j 组合键，多次按Ctrl+a, Ctrl+j 组合键，stopbits在1、2之间切换。

*** stopbits: 2 ***

*** stopbits: 1 ***

此处按Ctrl+a, Ctrl+f 组合键，多次按Ctrl+a, Ctrl+f 组合键，flow ctrl在RTS/CTS、xon/xoff、none 之间切换。

*** flow: RTS/CTS ***

*** flow: xon/xoff ***

*** flow: none ***

此处按Ctrl+a, Ctrl+y 组合键，多次按Ctrl+a, Ctrl+y 组合键，parity在even、odd ，none 之间切换。

*** parity: even ***

*** parity: odd ***

*** parity: none ***

此处按Ctrl+a, Ctrl+w 组合键，然后输入aa。

*** hex: aa
*** wrote 1 bytes ***

*** hex: bb
*** wrote 1 bytes ***

此处按Ctrl+a, Ctrl+x 组合键, 退出picocom。

Terminating...
Thanks for using picocom