二层交换机与路由器对接上网DHCP

用PC3模拟外网
添加vlan
vlan batch 2 3

1. 在LSW1上创建vlan,连接电脑的端口为access端口，连接路由器的端口为TRUNK

 int e 0/0/1
 port link-type access#设置端口为access
 port default vlan 2
 int e 0/0/2
 port link-type access#设置端口为access
 port default vlan 3
 int g 0/0/1
 port link-type trunk#设置端口为trunk
 port trunk allow-pass vlan all#设置端口放行所有vlan

2.路由器作为三层接口设置
配置终结子接口

sys
 vlan batch 2 3
 int g 0/0/1.1
 dot1q termination vid 2
 ip add 192.168.1.1 24
 arp broadcast enable
 q
  int g 0/0/1.2
 dot1q termination vid 3
 ip add 192.168.2.1 24
 arp broadcast enable#发布ARP广播

q
3.配置DHCP和DNS

 dhcp enable#开启DHCP功能
 int g 0/0/1.1
 dhcp select interface
 dhcp server dns-list 114.114.114.114 8.8.8.8#配置NDS
  dhcp enable
 int g 0/0/1.2
 dhcp select interface
 dhcp server dns-list 114.114.114.114 8.8.8.8

4.配置公网接口IP和静态路由

 int g 0/0/0
 ip add 200.0.0.2 24
 q
 ip route-static 0.0.0.0 0.0.0.0 200.0.0.1

5.配置NAT，使内网访问外网

 acl number 2001
 rule 5 permit source 192.168.0.0 0.0.255.255
 q
 int g 0/0/0
 nat outbound 2001
 q

结束
6测试
测试DHCP

测试外网连接