本文详细介绍了opnet中的ethcoax_net模型，包括总线模型和tap模型，涉及10Mbps以太网连接。重点讲解了模型的传播延迟、数据速率以及关键配置如propdel、txdel、coll等。
link
总线中分为两种:
- bus:总线的主干
- bus tap：总线的支线，用来连接总线主干和节点
bus:
The eth_coax_base model is an ethernet bus which can connect nodes with
bus receivers and transmitters via taps. This bus connects Ethernet
stations at 10 Mbps.
The propagation delay (in sec/m) through the medium is governed by the
propagation velocity. Per IEEE 802.3 the minimum required velocity
should be “0.65 * (speed of light)” - this yields a maximum propagation
delay of 5.1282 nanosecons/meter.
bus tap:
The eth_tap_base link model is an ethernet bus tap that connects a node
with bus receivers and transmitters to a bus at 10 Mbps.
注意其管道阶段的设置：
- propdel model:dbu_propdel
- txdel model:dbu_txdel
- coll model:dbu_coll
- error model:dbu_error
- ecc model:dbu_ecc
- c
最低0.47元/天 解锁文章
4204
被折叠的 条评论
为什么被折叠?
到【灌水乐园】发言
