ss528 22ap30 的调试

Booting Linux on physical CPU 0x0000000000 [0x410fd034]
Linux version 4.19.90 (liu7312@sina.com) (gcc version 7.3.0 (20220321)) #4 SMP Wed Mar 13 21:38:40 CST 2024
Machine model: SS528V100 Board
Memory limited to 512MB
cma zone is not set!
cma: Reserved 4 MiB at 0x000000005fc00000
psci: probing for conduit method from DT.
psci: PSCIv1.1 detected in firmware.
psci: Using standard PSCI v0.2 function IDs
psci: MIGRATE_INFO_TYPE not supported.
psci: SMC Calling Convention v1.1
random: get_random_bytes called from start_kernel+0xa8/0x374 with crng_init=0
percpu: Embedded 19 pages/cpu s38680 r8192 d30952 u77824
Detected VIPT I-cache on CPU0
CPU features: enabling workaround for ARM erratum 845719
Speculative Store Bypass Disable mitigation not required
Built 1 zonelists, mobility grouping on.  Total pages: 129024
Kernel command line: mem=512M console=ttyAMA0,115200 root=/dev/mtdblock2 rw rootfstype=jffs2 mtdparts=sfc:1M(boot),10M(kernel),21M(rootfs)
log_buf_len individual max cpu contribution: 4096 bytes
log_buf_len total cpu_extra contributions: 12288 bytes
log_buf_len min size: 16384 bytes
log_buf_len: 32768 bytes
early log buf free: 14612(89%)
Dentry cache hash table entries: 65536 (order: 7, 524288 bytes)
Inode-cache hash table entries: 32768 (order: 6, 262144 bytes)
Memory: 492748K/524288K available (5374K kernel code, 320K rwdata, 1328K rodata, 320K init, 243K bss, 27444K reserved, 4096K cma-reserved)
SLUB: HWalign=64, Order=0-3, MinObjects=0, CPUs=4, Nodes=1
rcu: Hierarchical RCU implementation.
rcu:    RCU event tracing is enabled.
NR_IRQS: 64, nr_irqs: 64, preallocated irqs: 0
GICv3: Distributor has no Range Selector support
GICv3: no VLPI support, no direct LPI support
GICv3: CPU0: found redistributor 0 region 0:0x0000000012440000
arch_timer: cp15 timer(s) running at 24.00MHz (phys).
clocksource: arch_sys_counter: mask: 0xffffffffffffff max_cycles: 0x588fe9dc0, max_idle_ns: 440795202592 ns
sched_clock: 56 bits at 24MHz, resolution 41ns, wraps every 4398046511097ns
Console: colour dummy device 80x25
Calibrating delay loop (skipped), value calculated using timer frequency.. 48.00 BogoMIPS (lpj=240000)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 1024 (order: 1, 8192 bytes)
Mountpoint-cache hash table entries: 1024 (order: 1, 8192 bytes)
ASID allocator initialised with 32768 entries
rcu: Hierarchical SRCU implementation.
smp: Bringing up secondary CPUs ...
Detected VIPT I-cache on CPU1
GICv3: CPU1: found redistributor 1 region 0:0x0000000012460000
CPU1: Booted secondary processor 0x0000000001 [0x410fd034]
Detected VIPT I-cache on CPU2
GICv3: CPU2: found redistributor 2 region 0:0x0000000012480000
CPU2: Booted secondary processor 0x0000000002 [0x410fd034]
Detected VIPT I-cache on CPU3
GICv3: CPU3: found redistributor 3 region 0:0x00000000124a0000
CPU3: Booted secondary processor 0x0000000003 [0x410fd034]
smp: Brought up 1 node, 4 CPUs
SMP: Total of 4 processors activated.
CPU features: detected: GIC system register CPU interface
CPU features: detected: 32-bit EL0 Support
CPU: All CPU(s) started at EL1
alternatives: patching kernel code
devtmpfs: initialized
clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns
futex hash table entries: 1024 (order: 4, 65536 bytes)
pinctrl core: initialized pinctrl subsystem
NET: Registered protocol family 16
vdso: 2 pages (1 code @ (____ptrval____), 1 data @ (____ptrval____))
DMA: preallocated 256 KiB pool for atomic allocations
Serial: AMBA PL011 UART driver
11040000.uart: ttyAMA0 at MMIO 0x11040000 (irq = 4, base_baud = 0) is a PL011 rev2
console [ttyAMA0] enabled
11041000.uart: ttyAMA1 at MMIO 0x11041000 (irq = 5, base_baud = 0) is a PL011 rev2
11042000.uart: ttyAMA2 at MMIO 0x11042000 (irq = 6, base_baud = 0) is a PL011 rev2
11043000.uart: ttyAMA3 at MMIO 0x11043000 (irq = 7, base_baud = 0) is a PL011 rev2
11044000.uart: ttyAMA4 at MMIO 0x11044000 (irq = 8, base_baud = 0) is a PL011 rev2
vgaarb: loaded
SCSI subsystem initialized
clocksource: Switched to clocksource arch_sys_counter
NET: Registered protocol family 2
IP idents hash table entries: 8192 (order: 4, 65536 bytes)
tcp_listen_portaddr_hash hash table entries: 256 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 4, 65536 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
UDP hash table entries: 256 (order: 1, 8192 bytes)
UDP-Lite hash table entries: 256 (order: 1, 8192 bytes)
NET: Registered protocol family 1
workingset: timestamp_bits=62 max_order=17 bucket_order=0
squashfs: version 4.0 (2009/01/31) Phillip Lougher
jffs2: version 2.2. (NAND) © 2001-2006 Red Hat, Inc.
Block layer SCSI generic (bsg) driver version 0.4 loaded (major 252)
io scheduler noop registered
io scheduler deadline registered (default)
io scheduler cfq registered
io scheduler mq-deadline registered (default)
io scheduler kyber registered
pl061_gpio 11090000.gpio_chip: PL061 GPIO chip @0x0000000011090000 registered
pl061_gpio 11091000.gpio_chip: PL061 GPIO chip @0x0000000011091000 registered
pl061_gpio 11092000.gpio_chip: PL061 GPIO chip @0x0000000011092000 registered
pl061_gpio 11093000.gpio_chip: PL061 GPIO chip @0x0000000011093000 registered
pl061_gpio 11094000.gpio_chip: PL061 GPIO chip @0x0000000011094000 registered
pl061_gpio 11095000.gpio_chip: PL061 GPIO chip @0x0000000011095000 registered
pl061_gpio 11096000.gpio_chip: PL061 GPIO chip @0x0000000011096000 registered
pl061_gpio 11097000.gpio_chip: PL061 GPIO chip @0x0000000011097000 registered
pl061_gpio 11098000.gpio_chip: PL061 GPIO chip @0x0000000011098000 registered
pl061_gpio 11099000.gpio_chip: PL061 GPIO chip @0x0000000011099000 registered
pl061_gpio 1109a000.gpio_chip: PL061 GPIO chip @0x000000001109a000 registered
pl061_gpio 1109b000.gpio_chip: PL061 GPIO chip @0x000000001109b000 registered
pl061_gpio 1109c000.gpio_chip: PL061 GPIO chip @0x000000001109c000 registered
pl061_gpio 1109d000.gpio_chip: PL061 GPIO chip @0x000000001109d000 registered
pl061_gpio 1109e000.gpio_chip: PL061 GPIO chip @0x000000001109e000 registered
pl061_gpio 1109f000.gpio_chip: PL061 GPIO chip @0x000000001109f000 registered
pl061_gpio 110a0000.gpio_chip: PL061 GPIO chip @0x00000000110a0000 registered
pl061_gpio 110a1000.gpio_chip: PL061 GPIO chip @0x00000000110a1000 registered
pl061_gpio 110a2000.gpio_chip: PL061 GPIO chip @0x00000000110a2000 registered
pl061_gpio 110a3000.gpio_chip: PL061 GPIO chip @0x00000000110a3000 registered
pl061_gpio 110a4000.gpio_chip: PL061 GPIO chip @0x00000000110a4000 registered
pl061_gpio 110a5000.gpio_chip: PL061 GPIO chip @0x00000000110a5000 registered
pl061_gpio 110a6000.gpio_chip: PL061 GPIO chip @0x00000000110a6000 registered
pl061_gpio 110a7000.gpio_chip: PL061 GPIO chip @0x00000000110a7000 registered
pl061_gpio 110a8000.gpio_chip: PL061 GPIO chip @0x00000000110a8000 registered
pl061_gpio 110a9000.gpio_chip: PL061 GPIO chip @0x00000000110a9000 registered
cacheinfo: Unable to detect cache hierarchy for CPU 0
brd: module loaded
loop: module loaded
sata ports number:0 WRONG!!!
phy phy-10390000.phy.0: phy init failed --> -22
ahci: probe of 10390000.sata failed with error -22
bsp-sfc bsp_spi_nor.0: SPI Nor ID Table Version 1.2
bsp-sfc bsp_spi_nor.0: all blocks is unlocked.
bsp-sfc bsp_spi_nor.0: mx25l25635f (32768 Kbytes)
3 cmdlinepart partitions found on MTD device sfc
Creating 3 MTD partitions on "sfc":
0x000000000000-0x000000100000 : "boot"
0x000000100000-0x000000b00000 : "kernel"
0x000000b00000-0x000002000000 : "rootfs"
SPI Nand ID Table Version 2.7
Cannot found a valid SPI Nand Device
bsp_spi_nand_probe(200): Error: driver probe, result: -19
gmac pinctrl type=rgmii0
libphy: bsp_gemac_mii_bus: probed
gmac pinctrl type=rgmii1
libphy: bsp_gemac_mii_bus: probed
libphy: Fixed MDIO Bus: probed