STM32F10x CPU低功耗模式之停机模式

/* 按键初始化（按键唤醒）*/
void User_Init(void)
{
    GPIO_InitTypeDef GPIO_InitStructure;
    EXTI_InitTypeDef EXTI_InitStructure;
    NVIC_InitTypeDef NVIC_InitStructure;

    RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA, ENABLE);

    /* 按键 KEY1、KEY2、KEY3、KEY4*/
    GPIO_InitStructure.GPIO_Pin = GPIO_Pin_11 ;
    GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
    GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IPU;
    GPIO_Init(GPIOA, &GPIO_InitStructure);

    EXTI_ClearITPendingBit(EXTI_Line11);
    EXTI_InitStructure.EXTI_Line = EXTI_Line11;
    EXTI_InitStructure.EXTI_Mode = EXTI_Mode_Interrupt;
    EXTI_InitStructure.EXTI_Trigger = EXTI_Trigger_Falling;
    EXTI_InitStructure.EXTI_LineCmd = ENABLE;
    EXTI_Init(&EXTI_InitStructure);

    NVIC_InitStructure.NVIC_IRQChannel = EXTI15_10_IRQn;
    NVIC_InitStructure.NVIC_IRQChannelPreemptionPriority = 0;
    NVIC_InitStructure.NVIC_IRQChannelSubPriority = 4;
    NVIC_InitStructure.NVIC_IRQChannelCmd = ENABLE;
    NVIC_Init(&NVIC_InitStructure);
}
/* 按键外部中断函数 */
void EXTI15_10_IRQHandler(void)
{
    if(EXTI_GetITStatus(EXTI_Line11) != RESET)
    {
        EXTI_ClearITPendingBit(EXTI_Line11);
        if(WakeUpState == 0)
            Flag_WakeUp = UPDATE;     // 唤醒成功标志
    }
}

/* 进入停机模式*/
void Sys_Enter_Stop(void)
{
    PWR_EnterSTOPMode (PWR_Regulator_LowPower, PWR_STOPEntry_WFI);
    WakeUpState = 0;
}

/*恢复系统时钟函数*/

/* 此段引用于某位大神，能否唤醒成功就靠这一段了*/

static void SysClkConfig_STOP(void)
{
    /* After wake-up from STOP reconfigure the system clock */
    /* Enable HSE */
    RCC_HSEConfig(RCC_HSE_ON);
    /* Wait till HSE is ready */
    while(RCC_GetFlagStatus(RCC_FLAG_HSERDY) == RESET)
    {}
    /* Enable PLL */
    RCC_PLLCmd(ENABLE);

    /* Wait till PLL is ready */
    while(RCC_GetFlagStatus(RCC_FLAG_PLLRDY) == RESET)
    {}
    /* Select PLL as system clock source */
    RCC_SYSCLKConfig(RCC_SYSCLKSource_PLLCLK);
    /* Wait till PLL is used as system clock source */
    while(RCC_GetSYSCLKSource() != 0x08)
    {}
}