Recently acquired a 2610-24-PWR and I want to use it for my Cisco phones (7940s and 7960s). I've already got Call Manager setup and currently these phones (10 phones) work through a switch module that I have in my 2800 series router. From the Cisco router/switch I have two vlans, VLAN 1 and VLAN 10. VLAN 1 is used for voice traffic and VLAN 10 is used for data traffic. VLAN 1 operates on the 172.18.1.x /24 subnet and VLAN 10 operates on the 192.168.1.x /24 subnet. Each port has the following configuration:
switchport trunk native vlan 10
switchport mode trunk
switchport voice vlan 1
mls qos trust dscp
auto qos voip trust
auto discovery qos
spanning-tree portfast
This seems to work just fine. If I ever add a new phone to this Cisco device the pone comes up just fine and I'm able to configure it in CUCM without issue.
I tried to replicate this as best I could on the Procurve but I don’t believe I have things working correctly. Below is output from that switch, can someone help guide me through this? It’s my first time working with a Procurve switch, thank.
… Also, I know to use crossover cables, the phones ARE powering up, they just aren’t getting their info from the tftp server that is providing configuration data to the phones.
vlan 1
name "voice"
untagged 1-23,25-28
ip address 172.18.1.55 255.255.255.0
tagged Trk1
exit
vlan 10
name "DATA"
tagged 1-23,25-28,Trk1
exit
power pre-std-detect
spanning-tree Trk1 priority 4
switchport trunk native vlan 10
switchport mode trunk
switchport voice vlan 1
mls qos trust dscp
auto qos voip trust
auto discovery qos
spanning-tree portfast
This seems to work just fine. If I ever add a new phone to this Cisco device the pone comes up just fine and I'm able to configure it in CUCM without issue.
I tried to replicate this as best I could on the Procurve but I don’t believe I have things working correctly. Below is output from that switch, can someone help guide me through this? It’s my first time working with a Procurve switch, thank.
… Also, I know to use crossover cables, the phones ARE powering up, they just aren’t getting their info from the tftp server that is providing configuration data to the phones.
vlan 1
name "voice"
untagged 1-23,25-28
ip address 172.18.1.55 255.255.255.0
tagged Trk1
exit
vlan 10
name "DATA"
tagged 1-23,25-28,Trk1
exit
power pre-std-detect
spanning-tree Trk1 priority 4