ETSI TS 102 658 V2.1.1 (2010.06)
1、Protocol architecture
(1)The base of the protocol stack is the Physical Layer (PL) , which is the layer 1.
(2)The data linklayer(DLL),which is the layer 2,shall handle sharing of the medium by a number of user ,at the DLL,the protocol stack shall be divied vertically into
two parts,1、the user plane(U-plane,),for transporting information without addressing capability (e.g.voice or data stream ),2、and the control plane(C-plane)for
signalling with addressing capability .
(3)The Call Control Layer(CCL),which is layer 3,lies in the C-plane and is responsible for control of the call (addressing ,facilities,etc),provides the services support
by the radio ,and supports the Data Service ,U-plane access at layer 2(DLL)support the voice service.
2、Architectural Configurations
A network of MS and /or BS shall be configured into one of three modes,Mode 1 ,Mode 2,Mode 3.With a network all entities shall be configured with the
matching mode .
1)、Peer-to-Peer Direct Network (Mode 1)
2)、Centralized Repeater Network (Mode 2)
A Sentralized BS Network illustrated in figure 4.3 is characterized by multiple MS (Mobile Station)communicating with a BS on up-link and down-link channels(i.e MS ftx=BS,frx=fuplink,MS frx=BS ftx=fdownlink),All Centralized communication is via the BS ,For polite operation, the BS is required to indicate on the down-link when the up-link is busy.
Signalling between entities is asynchronous using a traffic channel.
3)Managed Centralized Repeater Network(Mode 3)
待续。。。。。P20