cisco packet tracer 8.2.2(思科模拟器) nat地址转换企业典型配置案例

tonyhi6

已于 2024-06-16 20:40:56 修改

阅读量252

点赞数 2

分类专栏：交换路由安全文章标签：网络智能路由器 cisco

于 2024-06-10 00:00:00 首次发布

本文链接：https://blog.csdn.net/tonyhi6/article/details/139554683

版权

交换路由安全专栏收录该内容

23 篇文章 1 订阅

订阅专栏

1 拓扑图如下

2 配置如下

#交换机sw配置
enable
configure terminal
hostname sw1
int gigabitEthernet 1/0/1
no switchport
ip address  192.168.2.1 255.255.255.0
exit
interface GigabitEthernet1/0/2
no sw
ip address  192.168.3.2 255.255.255.0
exit
ip route  0.0.0.0 0.0.0.0  192.168.3.1
ip routing
copy running-config  startup-config

#路由器R1配置
enable
configure terminal
int  gigabitEthernet 0/0
no shut
ip address  192.168.3.1 255.255.255.0
ip nat inside
exit
int  gigabitEthernet 0/1
no shut
ip address  10.10.10.1 255.255.255.252
ip  nat outside
exit
ip route 192.168.2.0 255.255.255.0  192.168.3.2
access-list 10 permit 192.168.2.0 0.0.0.255
access-list 10 permit  192.168.3.0 0.0.0.255
ip nat inside  source  list 10  interface gigabitEthernet 0/1 overload
Ctrl+z
copy running-config startup-config