linux redis 关闭保护模式，允许外网访问配置。

当你在liunx下 安装好redis以后，如果需要外网访问，需要关闭保护模式否则连接失败：

DENIED Redis is running in protected mode because protected mode is enabled, no bind address was specified, no authentication password is requested to clients. In this mode connections are only accepted from the loopback interface. If you want to connect from external computers to Redis you may adopt one of the following solutions: 1) Just disable protected mode sending the command 'CONFIG SET protected-mode no' from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to 'no', and then restarting the server. 3) If you started the server manually just for testing, restart it with the '--protected-mode no' option. 4) Setup a bind address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside.

原因时默认redis需要设置管理员账号密码,开启了保护模式
所以如果第一次使用没有设置管理员,就会出现报错,关闭保护模式即可，
若远程主机需要访问redis服务器，可以修改redis.conf配置文件：

1. 绑定IP地址,看业务开放
   bind 0.0.0.0

2)Redis默认不是以守护进程的方式运行，可以通过该配置项修改，使用yes启用守护进程，设置为no

daemonize no

3)保护模式

protected-mode no

修改完毕以后，启动加载配置文件：
/usr/local/redis/bin/redis-server /usr/local/redis/conf/redis6379.conf